Nano-scale Analysis of Solute Clusters in an Al-Zn Alloy by 3DAP
نویسندگان
چکیده
منابع مشابه
Shape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملDAMPING CAPACITY AND MECHANICAL PROPERTIES OF Zn-Al ALLOY CASTINGS
This paper describes damping capac i t y and mechanical p roper t ies o f Zn-8-20%A1 and Zn-8-20%Al-0.02-0.04XMg a l l o y cast ings. Zn-8-20%A1 a l l o y casti ngs show h igh damping when quenched from 573K. Small amount o f Mg a d d i t i o n t o these a l l o y cast ings lowers damping capaci ty considerably b u t e f f e c t i v e t o reduce decomposition through aging a t 423K f o r 48hrs ...
متن کاملExperimental Analysis of Microstructure and Mechanical Behaviour in Fine Grained Al-Zn-Mg Alloy
The high strength Al-Zn-Mg alloy is widely used for structure components in critical aerospace applications. Small additions of scandium (Sc) often refine cast microstructure and mechanical properties by forming metastable Al3Sc dispersoids. The main role of the Al3Sc dispersoid is to prevent recrystallization during hot deformation and solution treatment. A new technique to apply for surface m...
متن کاملPrecipitation of a new platelet phase during the quenching of an Al-Zn-Mg-Cu alloy.
A previously undescribed high aspect ratio strengthening platelet phase, herein named the Y-phase, has been identified in a commercial Al-Zn-Mg-Cu alloy. Differential scanning calorimetry indicates that this phase only precipitates at temperature and cooling rate of about 150-250 °C and 0.05-300 K/s, respectively. This precipitate is shown to be responsible for a noticeable improvement in mecha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materia Japan
سال: 2007
ISSN: 1340-2625,1884-5843
DOI: 10.2320/materia.46.815