Nano Particle Coatings on α-alumina Powders by a Carbonate Precipitation

Nano-size Hydroxyapatite Powders Preparation by Wet-Chemical Precipitation Route

In this study, wet-chemical process was performed to prepare nano-size hydroxyapatite (HA) powders (≈10 nm) by varying concentration (low, medium and high) of the starting solutions in order to increase the amount of as-dried HA powders with different process conditions. Particle sizes and density were analyzed and differential thermal analysis was used to determine the glass transition (Tg) an...

AGGLOMERATION ASSESMENT OF NANO-SIZED ALUMINA POWDERS

Abstract: Nanoparticles exhibit a high reactivity and strong tendency towards agglomeration. In this study, aluminum oxide (alumina) nanoparticles were characterized by gas adsorption (BET), transmition electron microscopy (TEM) and photon correlation spectroscopy (PCS) techniques to assess the agglomeration of the particles. There is a good correlation between the BET and TEM measurements b...

Characterization of γ- and α-Fe2O3 nano powders synthesized by emulsion precipitation-calcination route and rheological behaviour of α-Fe2O3

Nano crystals of γ-Fe2O3 (maghemite) were synthesized by emulsion precipitation method using kerosene as oil phase, SPAN80 (sorbitane monooleate) as the surfactant and sodium hydroxide as the precipitating agent. The characterization of the samples by FTIR (Fourier transform infra-red) and XRD (X-ray diffraction) techniques confirmed the formation of γ-Fe2O3 (maghemite). Analysis by SEM (scanni...

Morphology investigation of alumina nano-powders prepared by a sol-gel combustion method

Highly sinterable alumina nano-powders have been synthesized by a sol-gel combustion method with glycine asfuel. The preparation involved the thermal decomposition of a chelating agent (fuel)-nitrate gel and theformation of amorphous precursors. The nanopowders calcined at 1100°C were characterized by X-ray powderdiffraction (XRD) and Scanning Electron Microscopy (SEM). It was found that the ch...

α - alumina coatings on WC / Co substrates by physical vapor deposition