Multivariable Correlation-based Tuning for Load Disturbance Rejection
نویسندگان
چکیده
منابع مشابه
Active Disturbance Rejection Control Tuning Employing the Lqr Approach for Decoupling Uncertain Multivariable Systems
The ADRC tuning is essentially a pole-placement technique and the desired performance is indirectly achieved through the location of the closed-loop poles. However, the final choice of these poles becomes a trial-and-error strategy. In contrast with pole-placement, in the LQR method, the desired performance objectives are directly and globally addressed by minimizing a quadratic function of ...
متن کاملA Generalized Design of Decoupling Multivariable Control for Disturbance Rejection
In this paper, a systematic procedure is proposed for the generalized design of decoupling multivariable controller, which may result in a complete decoupling, partial decoupling or no decoupling, to achieve a better disturbance rejection response. Before the decoupling, a relative load gain (abbr. RLG) is defined to determine which control loops need to be decoupled and which control loops don...
متن کاملCorrelation-Based Tuning of Linear Multivariable Decoupling Controller
The recently-proposed method for iterative correlation-based controller tuning is considered in this paper for the tuning of multivariable Linear Time Invariant (LTI) controllers. The parameters of the controller are updated directly using the data acquired in closed-loop operation. This approach allows one to tune some elements of the controller transfer function matrix to satisfy the desired ...
متن کاملPID controller with improved load-disturbance rejection
In this paper a two-degree-of-freedom (2DOF) IMC structure is considered for integrating process with deadtime to achieve improved load-disturbance response along with the set-point response. Set-point controller is designed considering desired speed of response of the closed-loop system. The load-disturbance controller is designed through direct synthesis approach and both the controllers are ...
متن کاملTuning for Smooth PID Control with Acceptable Disturbance Rejection
The objective of most published tuning rules is “tight” or fast control, subject to avhieving acceptable robustness. This gives a maximum limit on the controller gain. In industrial practice, however, the objective is often “smooth” or slow control, subject to achieving acceptable performance in terms of disturbance rejection. This paper provides the corresponding minimum limit on the controlle...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IFAC-PapersOnLine
سال: 2020
ISSN: 2405-8963
DOI: 10.1016/j.ifacol.2020.12.2258