Multiscale modelling of asymmetric rolling with an anisotropic constitutive law
نویسندگان
چکیده
منابع مشابه
Macroscopic constitutive law for Mastic Asphalt Mixtures from multiscale modeling
A well established framework of an uncoupled hierarchical modeling approach is adopted here for the prediction of macroscopic material parameters of the Generalized Leonov (GL) constitutive model intended for the analysis of flexible pavements at both moderate and elevated temperature regimes. To that end, a recently introduced concept of a statistically equivalent periodic unit cell (SEPUC) is...
متن کاملConstitutive Modelling for Anisotropic Damage in Woven E-Glass Reinforcements
Abstract: It is easy for composite laminates to be damaged by relative lower velocity impact which could give rise to internal delamination that will strongly weaken the compressive strength of laminates. In order to predict the occurrence of matrix failure, the elastic-brittle behaviors of fiber-reinforced composites were modeled constitutively by an anisotropic damage model. The dynamic tensi...
متن کاملAn anisotropic tertiary creep damage constitutive model for anisotropic materials
When an anisotropic material is subject to creep conditions and a complex state of stress, an anisotropic creep damage behavior is observed. Previous research has focused on the anisotropic creep damage behavior of isotropic materials but few constitutive models have been developed for anisotropic creeping solids. This paper describes the development of a new anisotropic tertiary creep damage c...
متن کاملConstitutive equations for an elastic material with anisotropic rigid particles.
In this paper we have derived constitutive equations for an elastic material with anisotropic rigid particles. We have included a dependence on the Finger tensor B and the orientation tensor Q in the expression for the free energy of the system. With this expression for the free energy we have derived an expression for the stress tensor up to second order in both these variables. We have shown ...
متن کاملInvestigation and Simulation of Wire Non-Asymmetric Rolling Process
The non-asymmetric rolling process of copper and brass wire has been simulated with the Abaqus software. Presented finite element model in this simulation of rolling predicted output curvature and contact surface width in the non-asymmetric mode (in equality of diameter of rollers, the rotational speed of the rollers and the rollers’ surface finish). The material used in this research has strai...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Comptes Rendus Mécanique
سال: 2018
ISSN: 1631-0721
DOI: 10.1016/j.crme.2018.06.001