Multi-phase Flow Simulations in Direct Iron Ore Smelting Reduction Process
نویسندگان
چکیده
منابع مشابه
A Comprehensive Static Model of an Iron Bath Smelting Reduction Process with Thick Slag for Alumina-Rich Iron Ore
Alumina-rich iron ore is a widely existed polymetallic deposit in the nature, and it has a high comprehensive utilization value. Because the alumina and iron contents of alumina-rich iron ore vary from each other, there are many different measures and processes to recover iron and alumina from the various kinds of alumina-rich iron ore. In the blast furnace (BF) ironmaking process, the alumina ...
متن کاملCarbon Monoxide Reduction of Iron Ore
C ERTAIN attention is paid today to the weaknesses of the classical blast furnace process, and interest is continuously increasing in methods for direct reduction without melting. Several different methods have been developed or suggested in the past, but so far only a few have been adopted for practical use. Another tendency in the iron industry of today is the change-over to concentrates, wit...
متن کاملThe Smelting of Manganese Carbonate Ore
The practice of manganese ferroalloy smelting has traditionally been based on utilising oxide ores which typically contain a high level of manganese. This preference for oxides has even been extended to the modification of natural carbonates into nodulized oxides. However smelting practices developed over the past 30 years have created a market for natural manganese carbonate ores, driven in pa...
متن کاملInteraction Mechanism between Refractory and Melts in Iron Bath Smelting Reduction Process
The corrosion behavior of three sorts of refractories based on alumina-graphite were studied by immersion tests. The melts included smelting reduction molten slag and corresponding carbon saturated molten iron. The influence of test temperature, FeO content in slag and specimen rotative velocity on the corrosion rate of refractories was examined. By means of SEM and EDS, the microstructure chan...
متن کاملdirect smelting of steel: process simulation
the design and manufacture of direct smelting reactors depends on the rate of the physico-chemical reactions that occur in the particles immersed into the molten bath. investigation of the effects of the important parameters that influence the smelting rate of the particles that in the furnace are both difficult and expensive if the aimed is to take measure meuts under real practical conditions...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2006
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.46.1158