Multi-Parametric Optimization of WEDM Process Using Desirability Function Analysis
نویسندگان
چکیده
منابع مشابه
Parametric Optimization of Wedm Using Grey Relational Analysis with Taguchi Method
Wire EDM is one of the latest advanced micro-machining techniques, where a thin wire (Ǿ= 0.25 mm) of tool electrode is fed on the work piece which gradually shears off the material during the machining process. This micro-machining process may help overcome the limitations and restriction faced during conventional mechanical machining process. This paper is based on wire-EDM machining of a part...
متن کاملMulti-response optimization of WEDM Process Parameters using the AHP and TOPSIS method
The work presents a multi response optimization approach to determine the optimal process parameters in wire electrical discharge machining process. Experiments have been conducted using six process parameters such as discharge current, pulse duration, pulse frequency, wire speed, wire tension and dielectric flow rate each at three levels for obtaining the responses like material removal rate, ...
متن کاملOptimization of the strain distribution in the roll forming process using the desirability function and finite element methods
Defects of the roll forming process are affected by amount and situation of the strains distribution. The effect of the process parameters on the strain distribution in the round cross section roll forming process has been studied. Finite element and response surface method have been used for process modelling. Then desirability functions approach and overlaid counter plots have been employed f...
متن کاملMulti-objective optimization in WEDM of D3 tool steel using integrated approach of Taguchi method & Grey relational analysis
In this paper, wire electrical discharge machining of D3 tool steel is studied. Influence of pulse-on time, pulse-off time, peak current and wire speed are investigated for MRR, dimensional deviation, gap current and machining time, during intricate machining of D3 tool steel. Taguchi method is used for single characteristics optimization and to optimize all four process parameters simultaneous...
متن کاملReview of Research Trends: Process Parametric Optimization of Wire Electrical Discharge Machining (WEDM)
The wire cut EDM is one of the most important machining process for technologists in the field of moulds, dies and in precision manufacturing .The wire electrical discharge machining producing parts with in very short period , the demand over the time increases extensively .So that an extensive research work has been carried out to optimize the parameters of the process by eliminating trial and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IARJSET
سال: 2017
ISSN: 2393-8021
DOI: 10.17148/iarjset/ncdmete.2017.21