Multi-height structures in injection molded polymer
نویسندگان
چکیده
منابع مشابه
Ion channel recordings on an injection-molded polymer chip.
In this paper, we demonstrate recordings of the ion channel activity across the cell membrane in a biological cell by employing the so-called patch clamping technique on an injection-molded polymer microfluidic device. The findings will allow direct recordings of ion channel activity to be made using the cheapest materials and production platform to date and with the potential for very high thr...
متن کاملSome mechanical properties of a highly cross-linked, microwave-polymerized, injection-molded denture base polymer.
PURPOSE The impact strength and the flexural properties of denture base materials are of importance in predicting their clinical performance upon sudden loading. This study compares the impact and transverse strengths and the flexural modulus of three denture base polymers. MATERIALS AND METHODS The investigation included a relatively new microwave-polymerized polyurethane-based denture mater...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملThermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملInjection molded microfluidic chips featuring integrated interconnects.
An injection molding process for the fabrication of disposable plastic microfluidic chips with a cycle time of 2 min has been designed, developed, and implemented. Of the sixteen commercially available grades of cyclo-olefin copolymer (COC) that were screened for autofluorescence and transparency to ultraviolet (UV) light, Topas 8007 x 10 was identified as the most suitable for production. A ro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microelectronic Engineering
سال: 2015
ISSN: 0167-9317
DOI: 10.1016/j.mee.2015.03.017