Multi-Angle Welding Jig
نویسندگان
چکیده
منابع مشابه
JIG: Jazz Improvisation Generator
This article presents JIG, a system for improvisation on jazz ballads. It was described previously in a Master’s Thesis [4]. JIG generates so called ’formulaic’ improvisations. It uses constraints, in combination with probability-driven randomness to generate note-attributes. In this way, numerous different improvisations can be generated on a single song. JIG has been incorporated in SaxEx, a ...
متن کاملResidual Stress and Deformation Analysis in Butt Welding on 6 mm SUS304 Steel with Jig Constraints Using Gas Metal Arc Welding
This article proposes a novel method for analyzing residual stress and deformation in butt welding on 6 mm SUS304 stainless steel plates, using MSC.MARC, a commercial finite element method software, to find the best location for jig fixtures that will minimize welding deformation. Simulation and experimental studies show that a distance of 100 mm between the jig center and the welding bead cent...
متن کاملScheduling in a Multi-robot Welding System
Multi-robot systems have been introduced actively in heavy industry in order to increase the productivity. However, since the configuration of workpiece is complex and multiple robots are disposed densely in a working area, collision between adjacent robots could occur. Because the collision prevents effective production, collision occurrence should be avoided. This paper reduces the problem of...
متن کاملMulti-Observations Initial Orbit Determination based on Angle-Only Measurements
A new approach with the ability to use the multiple observations based on the least square approach has been proposed for initial orbit determination. This approach considers the Earth’s Oblateness by using the developed Lagrange coefficients. The efficiency of the proposed method has been tested in two scenarios. The first scenario is to use the simulated and the second one is to utilize the r...
متن کاملA jig for measuring incisor inclination.
The aim of this study was to design and construct a jig for measuring the inclination of the upper incisors to the maxillary plane and of the lower incisors to the mandibular plane. After several prototypes had been tested, the required properties for a successful jig were identified and a simple inexpensive device was produced. Measurements obtained when using the jig on 51 subjects were compa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: American International Journal of Contemporary Research
سال: 2019
ISSN: 2162-139X,2162-142X
DOI: 10.30845/aijcr.v9n1p5