MoSi <sub>2</sub> /Al <sub>2</sub> O <sub>3</sub> /Feldspar Composites for Injection?Molded Ceramic Heating Elements
نویسندگان
چکیده
The cover illustrates the sintering of MoSi2/Al2O3/Feldspar heating elements fabricated by injection molding, thus allowing more complex geometries and economical element production, see article number 2100517 Dirk Penner co-workers. Different binder systems are investigated various shapes as shown in illustration produced tested. (Cover design: René Wick-Joliat)
منابع مشابه
Microwave Heating of Ceramic Composites
The microwave heating of a ceramic composite is modelled and analysed. The composite consists of many small ceramic particles embedded in a ceramic cement. The composite is assumed to be well insulated, and each particle is assumed to be in imperfect thermal contact with the surrounding cement. Based on these two assumptions an asymptotic theory exploiting the small Biot number and small non-di...
متن کاملFlexibility of experimental alumina/feldspar and SR ADORO dental composites.
INTRODUCTION Flexure of a dental composite can be detrimental to the success of a restoration. Flexibility considerations are thus important when comparing dental materials to optimize the success of resin restorations. AIMS AND OBJECTIVES Flexibility of 5.6 x 18.0 x 2.0 mm3 experimental alumina/feldspar and SR ADORO dental composites specimens were compared. It was hypothesized that alumina/...
متن کاملEstimation of Interfacial Shear in Ceramic Composites from Frictional Heating Measurements
A new approach for estimating the interfacial frictional shear stress in fiber-reinforced ceramics is presented. The approach is based upon measurement of the temperature rise which occurs during the cyclic loading of ceramic composites. This temperature rise, which is caused by the frictional slip of fibers within the composite, is related to the level of frictional shear stress which exists a...
متن کاملBioactive ceramic-reinforced composites for bone augmentation.
Biomaterials have been used to repair the human body for millennia, but it is only since the 1970s that man-made composites have been used. Hydroxyapatite (HA)-reinforced polyethylene (PE) is the first of the 'second-generation' biomaterials that have been developed to be bioactive rather than bioinert. The mechanical properties have been characterized using quasi-static, fatigue, creep and fra...
متن کاملBioactive Ceramic-polymer Composites for Tissue Replacement
Bone, at the ultra-structural level, is a composite with mechanical properties that can be matched by man-made composites. It serves as the template for developing bone replacement materials. Research on biomaterials analogous to bone was started in the early 1980s by incorporating bioactive particles into biocompatible polymers in order to produce bone substitutes. Hydroxyapatite reinforced hi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Engineering Materials
سال: 2021
ISSN: ['1527-2648', '1438-1656']
DOI: https://doi.org/10.1002/adem.202170033