Morphological Change and Recovery during Tempering of Ni<SUB>40</SUB>Zn<SUB>50</SUB>Cu<SUB>10</SUB> Martensite
نویسندگان
چکیده
منابع مشابه
The Precipitation of Carbides during Tempering of High Carbon Martensite*
perature range between 260° and 360°C. Jack showed that thin platelets of cementite formed at the beginning of this stage(10). In high carbon steels, the transformation twin interfaces are potent nucleation sites for the cementite formation and the cementite is related to the ferrite by Bagaryatskii's orientation relationship(2)(3)(11). Although there is no direct evidence of its existence in s...
متن کاملThe Silicon Effect in the Tempering of Martensite in Steels
High-silicon steels have long been known to possess exceptional resistance to tempering, but the reasons for this effect were unknown. We report here a study of the third stage of tempering of these steels, in which cementite is formed. In a 0.75 wt% C 1.4 wt% Si alloy steel, tempered for 1 hour at 380°C, it is found that silicon atoms are rejected from the growing cementite into the ferrite ma...
متن کاملGrain Refinement of Dual Phase Steel via Tempering of Cold-Rolled Martensite
A microstructure consisting of ultrafine grained (UFG) ferrite with average grain size of ~ 0.7 µm and dispersed nano-sized carbides was produced by cold-rolling and tempering of the martensite starting microstructure in a low carbon steel. Subsequently, fine grained dual phase (DP) steel consisting of equiaxed ferrite grains with average size of ~ 5 µm and martensite islands with average size ...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Influence of Tempering on the Microstructure & Properties of Martensite and Bainite developed in a Low-C High-Si Steel
Martensitic and bainitic steels are two types of widely used steels with excellent mechanical behaviors in automatic industry. It’s universally acknowledged that asquenched martensite possesses poor ductility and impact toughness, which should be tempered before putting into application. During tempering, as-quenched martensite changes from a hard and brittle microstructure to more ductile and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Institute of Metals
سال: 1984
ISSN: 0021-4434,2432-4701
DOI: 10.2320/matertrans1960.25.538