Monolayer Gas Adsorption on Graphene-Based Materials: Surface Density of Adsorption Sites and Adsorption Capacity
نویسندگان
چکیده
منابع مشابه
Gas adsorption properties of graphene-based materials.
Clean energy sources and global warming are among the major challenges of the 21st century. One of the possible actions toward finding alternative energy sources and reducing global warming are storage of H2 and CH4, and capture of CO2 by using highly efficient and low-cost adsorbents. Graphene and graphene-based materials attracted a great attention around the world because of their potential ...
متن کاملGas adsorption on a C60 monolayer.
The adsorption geometry of various gases on top of a C60 monolayer is investigated. The potential energy experienced by an adsorbate atom in the vicinity of a C60 molecule consists of Lennard-Jones interactions integrated over the spherical surface of the molecule. The adsorption potential exhibits strongly attractive sites which lead to a commensurate phase. The next adsorption sites are assum...
متن کاملMolecular adsorption on graphene.
Current studies addressing the engineering of charge carrier concentration and the electronic band gap in epitaxial graphene using molecular adsorbates are reviewed. The focus here is on interactions between the graphene surface and the adsorbed molecules, including small gas molecules (H(2)O, H(2), O(2), CO, NO(2), NO, and NH(3)), aromatic, and non-aromatic molecules (F4-TCNQ, PTCDA, TPA, Na-N...
متن کاملAdsorption of Dibenzothiophenes on Nanoporous Carbons: Identification of Specific Adsorption Sites Governing Capacity and Selectivity
Introduction Removal of dibenzothiophene (DBT) and 4,6dimethyldibenzothiophene (DMDBT), which are considered as refractory species, to low level of 30 ppm from diesel fuel is not a trivial task. Activated carbons have been shown as good adsorbents of dibenzothiophenic compounds [1-3]. Introduction of oxygen functional groups on the surface results in a specific adsorption of dibenzothiophenic s...
متن کاملOptimization of CO2 adsorption capacity and cyclical adsorption/desorption on tetraethylenepentamine-supported surface-modified hydrotalcite.
The objective of this research was to investigate CO2 adsorption capacity of tetraethylenepentamine-functionalized basic-modified calcined hydrotalcite (TEPA/b-cHT) sorbents at atmospheric pressure formed under varying TEPA loading levels, temperatures, sorbent weight to total gaseous flow rate (W/F) ratios and CO2 concentrations in the influent gas. The TEPA/b-cHT sorbents were characterized b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Surfaces
سال: 2020
ISSN: 2571-9637
DOI: 10.3390/surfaces3030031