Modified Johnson–Cook Model-based Numerical Simulation of Small Arms Bullets Penetration in the Aluminum Alloy Plates
نویسندگان
چکیده
منابع مشابه
Effect of welding parameters on penetration depth in FB-TIG welding of 5083 aluminum alloy
In the present study, effect of current, welding speed and preheat temperature during FB-TIG welding of AA5083 aluminum alloy was studied. Using the Taguchi method, 9 different tests were designed to investigate the effect of welding parameters on the penetration depth. Consistent with predictions, increasing the current and preheat temperature, and reducing the welding speed led to an increase...
متن کاملEffect of welding parameters on penetration depth in FB-TIG welding of 5083 aluminum alloy
In the present study, effect of current, welding speed and preheat temperature during FB-TIG welding of AA5083 aluminum alloy was studied. Using the Taguchi method, 9 different tests were designed to investigate the effect of welding parameters on the penetration depth. Consistent with predictions, increasing the current and preheat temperature, and reducing the welding speed led to an increase...
متن کاملNumerical Simulation and Experimental Validation of Residual Stresses in Water-Quenched Aluminum Alloy Castings
Aluminum alloy castings are normally water quenched after solution treatment to improve mechanical properties. Rapid water quenching can result in high-residual stress and severe distortion which significantly affect functionality and performance of the products. To optimize product design and durability, one needs to model and predict residual stress and distortion produced in the water-quench...
متن کاملPerforation of 5083-H116 Aluminum Armor Plates with Ogive-nose Rods and 7.62mm APM2 Bullets
We conducted an experimental and analytical study to understand the mechanisms and dominant parameters for ogive-nose rods and 7.62mm APM2 bullets that perforate 5083-H116 aluminum armor plates. The 20-mm-diameter, 95-mm-long, ogive-nose, 197g, hard steel rods were launched with a gas gun to striking velocities between 230-370m/s. The 7.62-mm-diameter, 10.7g, APM2 bullet consists of a brass jac...
متن کاملApplication of the GTN Model in Ductile Fracture Prediction of 7075-T651 Aluminum Alloy
In this paper the capability of Gurson-Tvergaard-Needleman (GTN) model in the prediction of ductile damage in 7075-T651 aluminum alloy is investigated. For this purpose, three types of specimens were tested: Standard tensile bars, Round notched bar (RNB) specimens and compact tension (C(T)) specimens. Standard tensile bar tests were used to obtain the mechanical properties of the material and t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science and Education of the Bauman MSTU
سال: 2017
ISSN: 1994-0408
DOI: 10.7463/0117.0000922