Modification of Hot-Wire Anemometers Frequency Bandwidth Measurement Method
نویسندگان
چکیده
منابع مشابه
Measurement of Thermal Conductivity of Magnesia Brick with Straight Brick Specimens by Hot Wire Method
As a result of a revision of the JIS system, the application of the hot wire method for determining thermal conductivity has been expanded from heat-insulating bricks to refractories with higher heat conductivity. In this regard, focusing on magnesia bricks, which are used in the safety lining of converters and a wide variety of other applications, the authors studied the possibility of applyin...
متن کاملSupply Voltage Compensation of Hot Wire Flow Measurement Device
Supply voltage compensation is important to keep the accuracy for hot wire/hot film gas flow sensors. A compensation experiment device is established, the two steps curve fitting is presented to determine the functional relations among flow、sensor output and supply voltage, the coefficient of fitting polynomial is determined by Least Square method, thus eliminating the influence of supply volta...
متن کاملAlgorithm to optimize transient hot-wire thermal property measurement.
The transient hot-wire method has been widely used to measure the thermal conductivity of fluids. The ideal working equation is based on the solution of the transient heat conduction equation for an infinite linear heat source assuming no natural convection or thermal end effects. In practice, the assumptions inherent in the model are only valid for a portion of the measurement time. In this st...
متن کاملDesign Modification of Rogowski Coil for Current Measurement in Low Frequency
The principle object of this paper is to offer a modified design of Rogowski coil based on its frequency response. The improvement of the integrator circuit for nullifying the phase difference between the waveforms of the measured-current and the corresponding terminal voltage is a further object of this investigation. This paper addresses an accurate, yet more efficient measuring and protect...
متن کاملElectrical Resistivity Measurement of the Molten Cordierite Glass Using Two-wire method
Electrical resistivity (ER) is a main parameter in the melting processes of glasses. However, its measurement is difficult at high temperatures. In this study the electrical resistivity of different cordierite glass samples in the molten state was measured in the temperature range of 1100˚C to 1550 ˚C using the two-wire method. It was attempted to decrease the electrical resistivity of the glas...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sensors
سال: 2020
ISSN: 1424-8220
DOI: 10.3390/s20061595