Modelling the temperature in joint friction of industrial manipulators
نویسندگان
چکیده
منابع مشابه
CFD Modelling of Friction Stir Welding of Aluminum to Steel butt joint
In this article effects of friction stir welding (FSW) tool rotational and traverse speeds were studied on heat generation and temperature distribution in welding zone of AA1100 aluminum alloy and A441 AISI joint. Computational fluid dynamics method was used to simulate the process with commercial CFD Fluent 6.4 package. To enhance the accuracy of simulation in this Study, the welding line that...
متن کاملRealistic Dynamic Simulation of an Industrial Robot with Joint Friction
This paper presents a realistic dynamic simulation of the closed-loop tip motion of a rigid-link manipulator with joint friction. The results from two simulation techniques are compared with experimental results. A six-axis industrial Stäubli robot is modelled. The LuGre friction model is used to account both for the sliding and pre-sliding regime. The manipulation task implies transferring a l...
متن کاملThe precise control of manipulators with joint friction: a base force/torque sensor method
Joint friction is a major problem in accurately controlling robot position during manipulator tasks involving small and slow motions. Previous research in this field suggests the use of either complex modeling and identification techniques, or expensive and delicate torque sensors that must be integrated into the manipulator. This paper proposes a simple, cost-effective method for compensating ...
متن کاملThe precise control of manipulators with high joint-friction using base force/torque sensing
Joint friction is a major problem in accurate robot position control, particularly during low-speed, small-amplitude tasks. This paper proposes a simple, practical, and e!ective method to compensate for joint friction, using a six-axis force/torque sensor mounted under the manipulator. From these measurements, joint torques are estimated and used in a torque controller, which virtually eliminat...
متن کاملVelocity Dependence of Joint Friction in Robotic Manipulators with Gear Transmissions
This paper analyses the problem of modelling joint friction in robotic manipulators with gear transmissions at joint velocities varying from close to zero until their maximum appearing values. It is shown that commonly used friction models that incorporate Coulomb, (linear) viscous and Stribeck components are inadequate to describe the friction behaviour for the full velocity range. A new frict...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Robotica
سال: 2017
ISSN: 0263-5747,1469-8668
DOI: 10.1017/s0263574717000509