Modelling of gas permeation through ceramic coatings produced by thermal spraying
نویسندگان
چکیده
منابع مشابه
Microwave Drilling of Ceramic Thermal-Barrier Coatings
The microwave drill is a novel process for creating shaped holes in nonconductive materials. Its inherent material selectivity makes the microwave drill ideally suited for the controlled removal of ceramic coatings from underlying metallic substrates. In this paper, it is shown that the microwave drill process can drill through ceramic thermal barrier coatings (TBCs) to uncover an array of simu...
متن کاملThermal Barrier Ceramic Coatings — A Review
Thermal barrier coatings (TBCs) provide effective thermal barrier to the components of gas turbine engines by allowing higher operating temperatures and reduced cool‐ ing requirements. Plasma spraying, electron-beam physical vapor deposition, and sol‐ ution precursor plasma spray techniques are generally used to apply the TBCs on the metallic substrates. The present article addresses the TBCs f...
متن کاملPlasma spraying of micro-composite thermal barrier coatings
The thermal barrier coatings (TBCs) by gas tunnel-type plasma spraying exhibited ceramic-composite features consisting of a host oxide matrix ceramic with an embedded second phase material. The densities of the composite TBC were found to be higher than those sprayed with 100wt% ZrO2 or Al2O3. In the coatings produced with powder mixtures of 50wt%, the embedded splats are found to have a relati...
متن کاملNovel Thermal Barrier Coatings Produced by Axial Suspension Plasma Spray
Ceramic Thermal Barrier Coatings (TBCs) on superalloy components are being used successfully in land-based gas turbine and aircraft engines. These coatings are generally made by either air plasma spraying (APS) or electron beam physical vapour deposition (EB-PVD). In general, EB-PVD TBCs have superior durability due to the columnar structure, but they are very expensive compared to APS TBCs. EB...
متن کاملMicrostructure of Laser Re-Melted AlCoCrCuFeNi High Entropy Alloy Coatings Produced by Plasma Spraying
An AlCoCrCuFeNi high-entropy alloy (HEA) coating was fabricated on a pure magnesium substrate using a two-step method, involving plasma spray processing and laser re-melting. After laser re-melting, the microporosity present in the as-sprayed coating was eliminated, and a dense surface layer was obtained. The microstructure of the laser-remelted layer exhibits an epitaxial growth of columnar de...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2008
ISSN: 1359-6454
DOI: 10.1016/j.actamat.2007.09.045