Modelling of damage Evolution and Fracture in 5182 H111 aluminium alloy
نویسندگان
چکیده
منابع مشابه
Nugget formation and growth during resistance spot welding of aluminium alloy 5182
Surface interaction at the worksheet/worksheet interface during resistance spot welding of aluminium alloy 5182 with spherical tip electrodes was investigated. Oxide layer cracking and nugget formation were focused. Both experimental work and finite element analysis were employed to explain the contact behaviour at this interface. It was found that sheet separation and thus bending occurred dur...
متن کاملTENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملMulti-scale modelling of damage and fracture
Recently, a novel multi-scale modelling approach for damage and fracture problems was presented. This method departs from classical computational homogenization (FE) and evolves to a discontinuity enriched scheme upon the localization detection. Rotating boundary conditions allow for microscale localization bands to develop. The formulation of the macroscopic cohesive discontinuity enables the ...
متن کاملPositron Lifetime Measurements of Subsurface Region in Aluminium Alloy and Aluminium Alloy Composite after Dry Sliding
This paper presents positron lifetime studies of the subsurface region of AK12 aluminium alloy and Al2O3-particle-reinforced AK12 aluminium alloy composite after sliding against steel in the pin-on-disc machine. The defect depth profile detected in the AK12 alloy extended up to 300 μm but for the composite AK12 the range of this profile was significantly shortened to less than ∼ 90 μm. The posi...
متن کاملFatigue and Anisotropic behaviours of cold rolled AA1200 Aluminium Alloy
This study examines the fatigue and anisotropy behaviour of cold rolled AA1200 aluminium alloy for light weight automotive connecting rod application. Aluminium (Al) 1200 ingots were melted at temperature of 680 0C (after one hour of heating) cast in sand mould and cast samples homogenized for 6 hrs at 480 0C. The cold rolling process was carried out after homogenisation for 10, 20, 30, 40 and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Sustainable Construction Materials and Technologies
سال: 2016
ISSN: 2458-973X
DOI: 10.29187/jscmt.2017.2