Modelling of a Bluff-Body Stabilised Premixed Flames Close to Blow-Off
نویسندگان
چکیده
منابع مشابه
Simulation of premixed turbulent flames
1. Introduction Premixed turbulent flames are of increasing practical importance and remain a significant research challenge in the combustion community. These flames have the potential to operate cleanly and efficiently over a broad range of fuels, and therefore to represent a key element in the implementation of low-emissions burners for a variety of industrial applications. However, it is di...
متن کاملA flamelet model for premixed stretched flames
A mass-based stretch rate is introduced. Combining this stretch rate with the conservation equations for premixed flames gives a set of quasi-one-dimensional flamelet equations, which describe the structure and the mass burning rate of these flames. An integral analysis is applied to the flamelet equations and subsequently a general expression for the mass burning rate of stretched flames is de...
متن کاملCalculations of bluff-body stabilized flames using a joint probability density function model with detailed chemistry
Joint probability density function (PDF) calculations are reported of the bluff-body stabilized flames (HM1, HM2, and HM3) and the results are compared with the available experimental data. The calculations are based on the modeled transport equation for the joint PDF of velocity, turbulence frequency, and composition (species mass fractions and enthalpy) using the interaction by exchange with ...
متن کاملAcoustic Detection of Blowout in Premixed Flames
Work to develop a practical, fast diagnostic technique to monitor the proximity of a combustor to blowout using measurements of the flame’s acoustic signature is described. The feasibility of this approach was demonstrated on three combustors with different flame holding mechanisms that are used in most practical combustion devices: pilot, swirl, and bluff-body stabilized flames. Extensive high...
متن کاملLarge eddy simulation/probability density function simulations of bluff body stabilized flames
0 10 20 30 −50 0 50 100 150 r (mm) U (m /s ) x/DB = 0.2 0 10 20 30 −10 −5 0 5 10 r (mm) V (m /s ) x/DB = 0.2 0 10 20 30 −50 0 50 100 150 r (mm) U (m /s ) x/DB = 0.6 0 10 20 30 −10 −5 0 5 10 r (mm) V (m /s ) x/DB = 0.6 0 10 20 30 −50 0 50 100 150 r (mm) U (m /s ) x/DB = 1.4 0 10 20 30 −10 −5 0 5 10 x/DB = 1.4 r (mm) V (m /s ) Experiment Raman et al. LES/HPDF Liu et al. Merci et al. Fig. 1. Mean ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Computation
سال: 2021
ISSN: 2079-3197
DOI: 10.3390/computation9040043