Modelling and Simulation Based Surface Characterization of Reverse- µEDM Fabricated Micro Pin-fins
نویسندگان
چکیده
منابع مشابه
Characterization , Modeling , and Optimization of Polymer Composite Pin Fins
Title of Dissertation: CHARACTERIZATION, MODELING, AND OPTIMIZATION OF POLYMER COMPOSITE PIN FINS Raj Bahadur, Doctor of Philosophy, 2005 Directed By: Professor, Avram Bar-Cohen, Mechanical Engineering Increasing electronic product manufacturing volumes and cooling requirements necessitate the use of new materials and innovative techniques to meet the thermal management challenges and to contri...
متن کاملModelling and characterization of InP-based high-speed pin-photodiode
In this paper, the characteristics and a model of a side illuminated twin waveguide, pin-photodiode based on scattering parameters, is proposed. The equivalent small-signal model involves both the photodetector and the coplanar waveguide transmission line models. The measurement of the optoelectronic conversion parameter (S21) of photodetector at 1.55 μm is done by an optical heterodyne techniq...
متن کاملHeat transfer enhancement from micro pin fins subjected to an impinging jet
An experimental investigation was carried out to study the single-phase stagnation point jet impingement heat transfer on smooth and micro pin fin structures using water and R134a. The experiments were carried out for a single jet (dj = 2.0 mm) impinging on a 2 2 mm micro-heater over a wide range of Reynolds numbers. Both an unfinned and a micro structured impingement surfaces were investigated...
متن کاملFlow Boiling Heat Transfer on Micro Pin Fins Entrenched in a Microchannel
Flow boiling of 1-methoxyheptafluoropropane (HFE 7000) in 222 m hydraulic diameter channels containing a single row of 24 inline 100 m pin fins was studied for mass fluxes from 350 kg /m2 s to 827 kg /m2 s and wall heat fluxes from 10 W /cm2 to 110 W /cm2. Flow visualization revealed the existence of isolated bubbles, bubbles interacting, multiple flow, and annular flow. The observed flow patte...
متن کاملMICROSTRUCTURE, HARDNESS AND SURFACE ROUGHNESS CHARACTERIZATION OF EBM FABRICATED Ti-6Al-4V SAMPLES
Electron beam melting (EBM) is among the modern additive manufacturing processes whereby metal powders are selectively melted to produce very complicated components with superior mechanical properties. In this study, microstructure, hardness, and surface roughness of EBM fabricated Ti6Al4V samples were characterized. The results showed that the microstructure consisted of epitaxially-grown prim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2019
ISSN: 2212-8271
DOI: 10.1016/j.procir.2019.03.299