Modeling the temperature distribution during laser hardening process
نویسندگان
چکیده
منابع مشابه
Modeling and Verification of Temperature Distribution and Residual Stress in Laser Aided Metal Deposition Process
Laser Metal Deposition is a novel, robust technique to manufacture or repair complex aerospace parts. However, as this process is very complicated and often operating at very high temperature, the resulting material behavior is hard to predict. The strain and stress induced by large thermal gradients in the fabrication process may cause parts failure such as cracking and distortion, so it is es...
متن کاملmodeling loss data by phase-type distribution
بیمه گران همیشه بابت خسارات بیمه نامه های تحت پوشش خود نگران بوده و روش هایی را جستجو می کنند که بتوانند داده های خسارات گذشته را با هدف اتخاذ یک تصمیم بهینه مدل بندی نمایند. در این پژوهش توزیع های فیزتایپ در مدل بندی داده های خسارات معرفی شده که شامل استنباط آماری مربوطه و استفاده از الگوریتم em در برآورد پارامترهای توزیع است. در پایان امکان استفاده از این توزیع در مدل بندی داده های گروه بندی ...
Modeling and Simulation with Experimental Validation of Temperature Distribution during Solidification Process in Sand Casting
The solidification of metals continues to be a phenomenon of great interest to physicists, metallurgists, casting engineers and software developers. It is a non-linear transient phenomenon, posing a challenge in terms of modelling and analysis. During the solidification of a casting in a mould, the heat-transfer between the casting and the mould plays a vital role. This paper attempts to study ...
متن کاملTemperature Distribution of Particles in a Laser Beam
This article studies the particle temperature distribution depending on the laser radiation power and the particle’s trajectory and velocity. The uneven heating of particles moving in the laser radiation field is identified. The regimes of laser heating without melting, with partial melting, and with complete particle melting are considered.
متن کاملModeling and Analysis of Viscous Dissipation Phenomenon on Temperature Distribution in the Process of Injection Explosive Fluid
The explosive viscous liquid becomes inject to warhead by discharge system. The injection device is consisted of a piston to move down and leads the viscous fluid through the cylindrical pipe towards the end of the duct. Then the viscous fluid leads into a convergent path that will be injected to the warhead or other injection equipment. In this project, the path of viscous fluid flow is divide...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Results in Physics
سال: 2020
ISSN: 2211-3797
DOI: 10.1016/j.rinp.2019.102883