Modeling on the Milling Force of Ball-end Milling Cutter Based on Z-MAP Method

Prediction of Chatter in CNC Machining based on Dynamic Cutting Force for Ball End Milling

This paper presents the suitable depth of cut, spindle speed and feed rate that will be chosen during machining. If thus parameters are not considered, this can provoke abnormal tool behavior such as chatter. Chatter will limit the tool life which only can be use for just a few times. To predict the chatter occurs, the parameters will be use are spindle speed, depth of cut and feed rate. CNC ma...

An Instantaneous Rigid Force Model For 3-Axis Ball-End Milling Of Sculptured Surfaces

An instantaneous rigid force model for prediction of cutting forces in ball-end milling of  sculptured surfaces is presented in this paper. A commercially available geometric engine is used to represent the cutting edge, cutter and updated part geometries. The cutter used in this work is an insert type ball-end mill. Intersecting an inclined plane with the cutter ball nose generates the cutting...

Study of the effective cutter radius for end milling of free-form surfaces using a torus milling cutter

Modeling and Analysis for Five-Axis High Speed Milling Process Based on Cutter Optimal Kinematics Performance

The overall goal of the research is the integration of geometric and mechanistic models for cutting process simulation and feedrate optimization. Five-axis milling methods are used in industries such as aerospace, automotive and mold for free-form surface machining. In these process, surface quality and material removal rate are of very important. Conservative cutting parameters have been mostl...

Experimental Study on Milling CFRP with Staggered PCD Cutter

Carbon fiber reinforced plastics (CFRP) have good physical properties, such as high specific strength and high specific modulus. However, cutting delamination, tearing and burr, etc. often occur in the machining process of CFRP, which results in the uncontrollability of machining surface quality and serious tool wear. In this paper, milling of CFRP with a staggered cutter was carried out, the c...