Modeling of thermoelectric module operation in inhomogeneous transient temperature field using finite element method
نویسندگان
چکیده
منابع مشابه
Transient Fluid Flow Modeling in Fractured Aquifer of Sechahoon Iron Mine Using Finite Element Method
Considering the fact that a large volume of iron reserve in the Sechahoon Iron Mine in Yazd Province has located under the water table, it is necessary to conduct a comprehensive study on water flow within the pit and its surroundings. The conceptual model of the aquifer was created using surface and underground geological information compared with water table data of the area of interest. In t...
متن کاملbuckling of viscoelastic composite plates using the finite strip method
در سال های اخیر، تقاضای استفاده از تئوری خطی ویسکوالاستیسیته بیشتر شده است. با افزایش استفاده از کامپوزیت های پیشرفته در صنایع هوایی و همچنین استفاده روزافزون از مواد پلیمری، اهمیت روش های دقیق طراحی و تحلیل چنین ساختارهایی بیشتر شده است. این مواد جدید از خودشان رفتارهای مکانیکی ارائه می دهند که با تئوری های الاستیسیته و ویسکوزیته، نمی توان آن ها را توصیف کرد. این مواد، خواص ویسکوالاستیک دارند....
Three Dimensional Transient Numerical Modeling of Temperature Distribution and Output Power in Photovoltaic Module
According to the effect of temperature on the output power of a photovoltaic module, this research tries to calculate the temperature distribution in a photovoltaic module by numerical solving of the energy balance equations. Therefore, its output power can be accurately predicted. For this purpose, several photovoltaic modules are modeled in detail in the COMSOL software. A new method for calc...
متن کاملA Proposed Modeling Method in Finite Element Slope Stability Analysis
Limit-equilibrium method (LEM) and finite element method (FEM) with strength reduction method (SRM) techniques are the most widely used analysis tools in slope stability assessment. Recently, researchers have reported that both factor of safety (FOS) values and failure surfaces obtained from LEM and FEM are generally in good agreement, except in some particular cases. In this paper, the FOS and...
متن کاملDiagnosis of Different Types of Air-Gap Eccentricity Fault in Switched Reluctance Motors Using Transient Finite Element Method
This paper presents a method for diagnosis of eccentricity fault in a switched-reluctance motor (SRM) during offline and standstill modes. In this method, the fault signature is differential induced voltage (DIV) achieved by injecting diagnostic pulses to the motor windings. It will be demonstrated by means of results that there is a correlation between differential induced voltage and eccentri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thermal Science
سال: 2014
ISSN: 0354-9836,2334-7163
DOI: 10.2298/tsci130112185n