Modeling of soot formation during partial oxidation of producer gas
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Aromatics Oxidation and Soot Formation in Flames
Personnel involved: Prof. Jack B. Howard, PI. Department of Chemical Engineering, MIT Dr. Henning Richter, Research Associate, Department of Chemical Engineering, MIT Murray J. Height, Graduate Student, Department of Chemical Engineering, MIT Timothy G. Benish, Graduate Student, Department of Chemical Engineering, MIT Dr. Peter Hebgen, Postdoctoral Associate, Department of Chemical Engineering,...
متن کاملHydrogen or Soot?: Partial Oxidation of High-boiling Hydrocarbon Wastes
An increased demand on hydrogen, which is essential for a deeper hydrorefining of petroleum oils to ensure better quality of motor fuels (from the point of view of exhaust emissions) motivate research on partial oxidation (POX) of high-boiling hydrocarbons residues or alternative biomass waste1–4. Process POX is based on the reaction between raw material and oxygen in the presence of water vapo...
متن کاملModeling of the Combustion Oscillations and Soot Formation in Aerovalved Pulse Combustors
This paper describes the modifications and evolution of a thermal pulse combustionmodel for predicting the combustion oscillations of an aerovalved 250 kW pulse combustorincorporating a soot formation-combustion model. Validation of the model is carried out from theexperimental data of an aerovalved Helmholtz type pulse combustor, where a sinusoidal air inlet massflow coupled with pressure osci...
متن کاملThree-Dimensional Modeling of Combustion Process, Soot and NOx formation In a Direct-injection Diesel Engine
This paper is presented to study the combustion process and emissions in a direct injection diesel engine. Computations are carried out using a three-dimensional model for flows, sprays, combustion and emissions in Diesel engines. Interactions between combustion and emissions with flow field are considered and it is shown that soot mass fraction increases at regions with low turbulence inten...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Fuel
سال: 2013
ISSN: 0016-2361
DOI: 10.1016/j.fuel.2012.10.061