Modeling of cold extrusion processes using kinematic trapezoidal modules
نویسندگان
چکیده
منابع مشابه
dedekind modules and dimension of modules
در این پایان نامه، در ابتدا برای مدول ها روی دامنه های پروفر شرایط معادل به دست آورده ایم و خواصی از ددکیند مدول ها روی دامنه های پروفر مشخص کرده ایم. در ادامه برای ددکیند مدول های با تولید متناهی روی حلقه های به طور صحیح بسته شرایط معادل به دست آورده ایم و ددکیند مدول های ضربی را مشخص کرده ایم. گزاره هایی در مورد بعد ددکیند مدول ها بیان کرده ایم. در پایان، قضایای lying over و going down را برا...
15 صفحه اولscour modeling piles of kambuzia industrial city bridge using hec-ras and artificial neural network
today, scouring is one of the important topics in the river and coastal engineering so that the most destruction in the bridges is occurred due to this phenomenon. whereas the bridges are assumed as the most important connecting structures in the communications roads in the country and their importance is doubled while floodwater, thus exact design and maintenance thereof is very crucial. f...
Modelling of cold extrusion with experimental verification
This paper reports on an experimental and finite element analysis (FEA) of the cold extrusion of high-grade (AA1100) aluminium. The influence of die angle, reduction ratio and die land on the extrusion force during the extrusion process was investigated. A forward extrusion die was designed and manufactured for the purpose of the experimental research. Interchangeable elements of the extrusion ...
متن کاملDesign of Robot Gripper Jaws based on Trapezoidal Modules
1 This work was supported in part by Adept Technology, Inc., a 2000 MICRO grant from the State of California, NSF grant CDA-9726389, and NSF Presidential Faculty Fellow Award IRI-9553197. 2 For further information please contact [email protected]. ABSTRACT Assembly line reliability can be increased if grippers are carefully designed to capture and align parts. Jaw design depends on the...
متن کاملModeling and simulation of forward Al extrusion process using FEM
The main objective of this paper is to study the effect of extrusion parameters (extrusion stresses and temperature) and die geometry, i.e. extrusion radius, on the extruded aluminum quality using FEM Simulation Technique. For this purpose, the general FEA Software ABAQUS was used to set up the finite element model of the warm aluminum extrusion in two dimensions (2D). Aluminum alloy Al-2014 wa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: FME Transactions
سال: 2020
ISSN: 1451-2092,2406-128X
DOI: 10.5937/fme2002357h