Model-Based Compensation of Rate-Dependent Hysteresis in a Piezoresistive Strain Sensor
نویسندگان
چکیده
منابع مشابه
Hysteresis Compensation of Piezoresistive Carbon Nanotube/Polydimethylsiloxane Composite-Based Force Sensors
This paper provides a preliminary study on the hysteresis compensation of a piezoresistive silicon-based polymer composite, poly(dimethylsiloxane) dispersed with carbon nanotubes (CNTs), to demonstrate its feasibility as a conductive composite (i.e., a force-sensitive resistor) for force sensors. In this study, the potential use of the nanotube/polydimethylsiloxane (CNT/PDMS) as a force sensor ...
متن کاملA Strain Range Dependent Cyclic Plasticity Model
Hysteresis loop curves are highly important for numerical simulations of materials deformation under cyclic loadings. The models mainly take account of only the tensile half of the stabilized cycle in hysteresis loop for identification of the constants which don’t vary with accumulation of plastic strain and strain range of the hysteresis loop. This approach may be quite erroneous particularly ...
متن کاملShort-carbon-fiber-reinforced epoxy as a piezoresistive strain sensor
Epoxy containing 5.5 vol.% short carbon fibers was found to be piezoresistive strain sensor, such that the magnitude of the reversible fractional increase in electrical resistance per unit strain was 6-23 under tension and 29-31 under compression. These values are much higher than those of previously reporied composite piezoresistive materials. The reversible fractional increase in resistance w...
متن کاملNew Design of Mems piezoresistive pressure sensor
The electromechanical analysis of a piezoresistive pressure microsensor with a square-shaped diaphragm for low-pressure biomedical applications is presented. This analysis is developed through a novel model and a finite element method (FEM) model. A microsensor with a diaphragm 1000 „m length and with thickness=400 µm is studied. The electric response of this microsensor is obtained with applyi...
متن کاملA High Performance Torque Sensor for Milling Based on a Piezoresistive MEMS Strain Gauge
In high speed and high precision machining applications, it is important to monitor the machining process in order to ensure high product quality. For this purpose, it is essential to develop a dynamometer with high sensitivity and high natural frequency which is suited to these conditions. This paper describes the design, calibration and performance of a milling torque sensor based on piezores...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Industrial Electronics
سال: 2019
ISSN: 0278-0046,1557-9948
DOI: 10.1109/tie.2018.2884204