Mode Couplers and Converters Based on Dual-Core Hollow-Core Photonic Bandgap Fiber
نویسندگان
چکیده
منابع مشابه
Gas Sensor Based on Large Hollow-Core Photonic Bandgap Fiber
One concern in using photonic band-gap fiber (PBGF) as a gas sensor is the response time. In this type of the gas sensors, response time is the time required for gas to diffuse into the hollow-core. So considering a large hollow-core PBGF (HC-PBGF), the response time can be significantly reduced. But in the large HC-PBGF, the fundamental issue is the presence of higher order modes (HOMs). Somet...
متن کاملIn-fiber polarimeters based on hollow-core photonic bandgap fibers.
In-fiber polarimeters or polarization mode interferometers (PMIs) are fabricated by cascading two CO2-laser-induced in-fiber polarizers along a piece of hollow-core photonic bandgap fiber. Since the two interfering beams are the orthogonal polarizations of the fundamental mode, which are tightly confined to the core and have much lower loss than higher order modes, the PMIs can have either shor...
متن کاملNonlinear dual-core photonic crystal fiber couplers.
We study nonlinear modes of dual-core photonic crystal fiber couplers made of a material with the focusing Kerr nonlinearity. We find numerically the profiles of symmetric, antisymmetric, and asymmetric nonlinear modes and analyze all-optical switching generated by the instability of the symmetric mode. We also describe elliptic spatial solitons controlled by the waveguide boundaries.
متن کاملDetection of acoustic pressure with hollow-core photonic bandgap fiber.
We report the results of our preliminary investigation on the use of hollow-core photonic bandgap fiber (HC-PBF) for hydrophone application. The response of the commercial HC-1550-02 fiber to acoustic pressure, in terms of normalized responsivity (NR), is measured to be - 334.4 dB re 1 microPa(-1). This agrees well with the theoretically predicated value of -331.6 dB re 1 microPa(-1) and is abo...
متن کاملA hollow-core photonic bandgap fiber polarization controller.
A polarization controller was built by pressurizing laterally three segments of a commercial hollow-core photonic bandgap fiber. By varying the magnitudes of the applied pressures, the output state of polarization showed a good coverage of all the possible polarization states on the surface of the Poincaré sphere.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Photonics Journal
سال: 2018
ISSN: 1943-0655,1943-0647
DOI: 10.1109/jphot.2018.2810059