Mixed-Mode I/II fracture behavior of asymmetric composite joints
نویسندگان
چکیده
منابع مشابه
Mixed-mode Fracture Analyses of Plastically- Deforming Adhesive Joints
A mode-dependent embedded-process-zone (EPZ) model has been developed and used to simulate the mixed-mode fracture of plastically deforming adhesive joints. Mode-I and mode-II fracture parameters obtained from previous work have been combined with a mixed-mode failure criterion to provide quantitative predictions of the deformation and fracture of mixed-mode geometries. These numerical calculat...
متن کاملMixed-mode I/II Interlaminar Fracture of CF/PEI Composite Material
Failures in composite materials occur mainly due to interlaminar fracture, also called delamination, between laminates. This indicates that characterizing interlaminar fracture toughness is the most effective factor in the fracture of composite materials. This study reports investigation on mixed-mode interlaminar fracture behaviour in woven carbon fibre/polyetherimide (CF/PEI) thermoplastic co...
متن کاملTensile-shear transition in mixed mode I/III fracture
The propensity of the transition of fracture type in either brittle or ductile cracked solid under mixed-mode I and III loading conditions is investigated. A fracture criterion based on the competition of the maximum normal stress and maximum shear stress is utilized. The prediction of the fracture type is determined by comparing smax=rmax at a critical distance from the crack tip to the materi...
متن کاملMixed Mode Fracture Analysis of Multiple Interface Cracks
This paper contains a theoretical formulation of multiple interface cracks in two bonded dissimilar half planes subjected to in-plane traction. The distributed dislocation technique is used to construct integral equations for a dissimilar mediums weakened by several interface cracks. These equations are of Cauchy singular type at the location of dislocation, which are solved numerically to obta...
متن کاملElastic-plastic Mode-ii Fracture of Adhesive Joints
A numerical study of the elastic-plastic mode-II fracture of adhesive joints is presented in this paper. A traction-separation law was used to simulate the mode-II interfacial fracture of adhesively-bonded end-notched flexure (E.N.F.) specimens loaded in three-point bending, with extensive plastic deformation accompanying failure. The fracture parameters for the traction-separation law were det...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2016
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2016.06.237