Mixed mode fracture criteria on adhesive joints.
نویسندگان
چکیده
منابع مشابه
Mixed-mode Fracture Analyses of Plastically- Deforming Adhesive Joints
A mode-dependent embedded-process-zone (EPZ) model has been developed and used to simulate the mixed-mode fracture of plastically deforming adhesive joints. Mode-I and mode-II fracture parameters obtained from previous work have been combined with a mixed-mode failure criterion to provide quantitative predictions of the deformation and fracture of mixed-mode geometries. These numerical calculat...
متن کاملElastic-plastic Mode-ii Fracture of Adhesive Joints
A numerical study of the elastic-plastic mode-II fracture of adhesive joints is presented in this paper. A traction-separation law was used to simulate the mode-II interfacial fracture of adhesively-bonded end-notched flexure (E.N.F.) specimens loaded in three-point bending, with extensive plastic deformation accompanying failure. The fracture parameters for the traction-separation law were det...
متن کاملMixed Mode Fracture Toughness of an Adhesive Bonded Joint
Adhesive joints are continuously emerging as candidate to replace traditional fastening systems, such as riveting or welding, in primary structural applications. A wide class of components belonging to electronic, automotive and aerospace industries contains adhesive joints, however, the reliability during service constitutes a major technical problem as these contain flaws. Therefore, their us...
متن کاملInterfacial mixed-mode fracture of adhesive bonds undergoing large deformation
Interfacial fracture of adhesive bonds undergoing large-scale yielding is studied using a combined experimental/ finite-element approach. The full range of in-plane mode mixity is produced over bond thickness ranging from 30 to 500 lm using the scarf and the ENF joint geometries. Novel techniques for introducing pre-cracks and surface decoration, together with in situ observations, facilitate a...
متن کامل3D Mixed-Mode Delamination Fracture Criteria–An Experimentalist’s Perspective
Many delamination failure criteria based on fracture toughness have been suggested over the past few decades, but most only covered the region containing mode I and mode II components of loading because that is where toughness data existed. With new analysis tools, more 3D analyses are being conducted that capture a mode III component of loading. This has increased the need for a fracture crite...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1990
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.39.1095