Mirror finishing Using Laser-Induced Periodic Surface Structures
نویسندگان
چکیده
منابع مشابه
Towards Friction Control using laser-induced periodic Surface Structures
This paper aims at contributing to the study of laser-induced periodic surface structures (LIPSS) and the description of their tribological properties in order to facilitate the knowledge for contact mechanical applications. To obtain laser parameters for LIPSS formation, we propose to execute two D2-Experiments. For the transfer of results from static experiments to areas of LIPSS we propose t...
متن کاملLaser-induced periodic annular surface structures on fused silica surface
We report on the formation of laser-induced periodic annular surface structures (LIPASS) on fused silica irradiated with multiple femtosecond laser pulses. This novel morphology emerges after the disappearance of the conventional laser induced periodic surface structures (LIPSS), under successive laser pulse irradiation. It is independent of the laser polarization and universally observed for d...
متن کاملSurface-Wave Suppression Using Periodic Structures
The objective of this paper is to design impedance surfaces for the solution of the problem of electromagnetic compatibility of antennas. In a recent paper, corresponding surfaces were used to reduce coupling between antennas located on a plane. These surfaces were made artificially, e.g., by loading a conducting surface with corrugations. The design of the impedance structure is done for a giv...
متن کاملStatistical Model of Laser Surface Finishing Using Design of Experiments
In previous work, laser polishing indirect-SLS metal parts was achieved using a Nd:YAG laser raster scanned at high speed. This work showed surface roughness could effectively be reduced by means of shallow surface melting. Surface area roughness data, Ra, was obtained by line profilometry measurements of the polished samples according to a modified procedure based on the ASME standard for surf...
متن کاملSub-Diffraction Limited Writing based on Laser Induced Periodic Surface Structures (LIPSS)
Controlled fabrication of single and multiple nanostructures far below the diffraction limit using a method based on laser induced periodic surface structure (LIPSS) is presented. In typical LIPSS, multiple lines with a certain spatial periodicity, but often not well-aligned, were produced. In this work, well-controlled and aligned nanowires and nanogrooves with widths as small as 40 nm and 60 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 2007
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.73.1159