Minimum weight design of rotorcraft blades with multiple frequency and stress constraints
نویسندگان
چکیده
منابع مشابه
Optimal selection of topologies for the minimum-weight design of continuum structures with stress constraints
This paper presents a method for assisting the optimal selection of topologies for the minimum-weight design of continuum structures subject to stress constraints by using the performance index (PI ). A performance index is developed for evaluating the efficiency of structural topologies based on the scaling design approach. This performance index is incorporated in the evolutionary structural ...
متن کاملTopology optimization of structures: A minimum weight approach with stress constraints
Sizing and shape structural optimization problems are normally stated in terms of a minimum weight approach with constraints that limit the maximum allowable stresses and displacements. However, topology structural optimization problems have been usually stated in terms of a maximum stiffness (minimum compliance) approach. In this kind of formulations, the aim is to distribute a given amount of...
متن کاملMINIMUM WEIGHT AND DRIFT DESIGN OF STEEL MOMENT FRAMES SUBJECTED TO BLAST
Design of blast resistant structures is an important subject in structural engineering, attracting the attention of governments, researchers, and engineers. Thus, given the benefits of optimization in engineering, development and assessment of optimization methods for optimum design of structures against blast is of great importance. In this research, multi-objective optimization of steel momen...
متن کاملISOGEOMETRIC TOPOLOGY OPTIMIZATION OF STRUCTURES CONSIDERING WEIGHT MINIMIZATION AND LOCAL STRESS CONSTRAINTS
The Isogeometric Analysis (IA) is utilized for structural topology optimization considering minimization of weight and local stress constraints. For this purpose, material density of the structure is assumed as a continuous function throughout the design domain and approximated using the Non-Uniform Rational B-Spline (NURBS) basis functions. Control points of the density surface are...
متن کاملDesign of Composite Risers for Minimum Weight
The use of composite materials in offshore engineering for deep sea oil production riser systems has drawn considerable interest due to the potential weight savings and improvement in durability. The design of composite risers consists of two stages: (1) local design based on critical local load cases, and (2) global analysis of the full length composite riser under global loads and assessment ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: AIAA Journal
سال: 1990
ISSN: 0001-1452,1533-385X
DOI: 10.2514/3.10431