Minimum Porosity Formation in Pressure Die Casting by Taguchi Method

Optimization of Process Parameters of Pressure Die Casting using Taguchi Methodology

The present work analyses different parameters of pressure die casting to minimize the casting defects. Pressure diecasting is usually applied for casting of aluminium alloys. Good surface finish with required tolerances and dimensional accuracy can be achieved by optimization of controllable process parameters such as solidification time, molten temperature, filling time, injection pressure an...

Materials on Dies for Pressure Die Casting

In the contribution the stress of die materials of thermal fatigue is defi ned and material life is derived theoretically and compared with the measured values. The important properties of the die materials as thermal conductivity, coeffi cient of thermal expansivity, modulus of elasticity and mechanical properties are described. Binding to it single die materials as carbon steels and chrome-tu...

Determination of Minimum Miscibility Pressure by Analytical Method

The analytical theory of one dimensional, dispersion free miscible displacement of oil by injection gas with nc component has shown that: the MMP is the lowest pressure at which any one of the initial oil, injection gas or crossover key tie lines becomes critical, which means that its length approaches to zero. In this paper, we propose a method for a solving multi component syst...

Semisolid Processing of Al/β-SiC Composites by Mechanical Stirring Casting and High Pressure Die Casting

Aluminium Foam and Magnesium Compound Casting Produced by High-Pressure Die Casting

Nowadays, fuel consumption and carbon dioxide emissions are two of the main focal points in vehicle design, promoting the reduction in the weight of vehicles by using lighter materials. The aim of the work is to evaluate the influence of different aluminium foams and injection parameters in order to obtain compound castings with a compromise between the obtained properties and weight by high-pr...