Minimizing friction, wear, and energy losses by eliminating contact charging
نویسندگان
چکیده
منابع مشابه
A Comparative Study of Tooth Wear, Mechanical Power Losses and Efficiency in Normal and High Contact Ratio Asymmetric Spur Gears
The surface tooth wear which occurs at the gear contact region due to inadequate contact strength of the tooth is one of the predominant modes of gear failures. Currently, higher contact ratio spur gears are increasingly used in power transmission applications such as aircraft, wind turbine, automobiles and compact tracked vehicles due to their high load carrying capacity. In this work, the di...
متن کاملNanoscale friction and wear maps.
Friction and wear are part and parcel of all walks of life, and for interfaces that are in close or near contact, tribology and mechanics are supremely important. They can critically influence the efficient functioning of devices and components. Nanoscale friction force follows a complex nonlinear dependence on multiple, often interdependent, interfacial and material properties. Various studies...
متن کاملStudy on Friction and Wear Properties of Pantograph Strip/Copper Contact Wire for High-Speed Train
A series of experiments on friction and wear properties of carbon strip rubbing against copper contact wire is performed on high-speed friction and wear tester with electric current. The results show that the friction coefficient is generally maintained between 0.24 and 0.37. In the absence of electric current, the coefficient of friction is higher than that in the presence of electric current....
متن کاملA Triboscopic Investigation of the Wear and Friction of MoS2 in a Reciprocating Sliding Contact
Reciprocating sliding tests with ball-on-flat geometry were performed on a duplex coating at low speeds in moist air (RH=60%). The coating, 55 nm MoS2 on 35 nm of TiN, was deposited by ion-beam assisted deposition onto a steel substrate. Friction coefficient (μ) and electrical contact resistance (Rc) measurements were recorded at ~2μm intervals along the track; these spatially resolved measurem...
متن کاملDry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning
Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science Advances
سال: 2018
ISSN: 2375-2548
DOI: 10.1126/sciadv.aau3808