Miniature Thick Film Resistors for Microwave Integrated Circuits
نویسندگان
چکیده
منابع مشابه
Thick Film Resistors Ndt by Electro-ultrasonic Spectroscopy
The non-linear electro-ultrasonic spectroscopy was used as a non-destructive testing method for the polymer based and cermet thick film resistors evaluation. We carried out the correlation between this method and standard testing methods as noise spectroscopy and the third harmonic voltage measurements. The measuring set-up with the ultrasonic transducer working on the frequency range 10 kHz to...
متن کاملNoise properties of thick-film resistors in extended temperature range
Results of thorough experimental studies on electrical properties of thick-film resistors (TFRs) have been overviewed and summarized. Experiments covered resistance and noise measurements in wide temperature range. Low-frequency noise spectroscopy has been used for the investigations of fluctuating phenomena. Sample resistors were prepared of various combinations of commercial and laboratory-ma...
متن کاملIntegrated metal magnetic film coupled line circulators for monolithic microwave integrated circuits
A new structure of integrated planar metal magnetic film coupled line (MMFCL) circulators is presented, in which a metal magnetic film is used instead of ferrite materials. Simulation was performed with HFSS based on coupled-mode theory. An insertion loss of 4 dB and isolation of 13.5 dB between S21 and S12 over a frequency band of 3 GHz (from 36.5 to 39.5 GHz) were realised for a three-port MM...
متن کاملMicrovaristors in thick-film and LTCC circuits
ZnO-based varistors protect electronic circuits against overvoltage. High temperature from the range of 1150–1300 C is required for proper sintering of such material. Varistor inks with lower firing temperature are needed for application in thick-film and LTCC technology. ZnO-based thick-film composition was prepared and varistors were fabricated on alumina and LTCC substrate. Different topolog...
متن کاملThin-film passives in RF/microwave circuits
Until recently, most microwave capacitors were based on fired multilayer ceramic technology. In this process, layers of highly conductive electrode metal alloys are interleaved with low-loss ceramic dielectrics in a multilayer fashion until the target capacitance is obtained. The resulting stack is then sintered into a monolithic structure in a high-temperature firing process. This process cont...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Active and Passive Electronic Components
سال: 1991
ISSN: 0882-7516,1563-5031
DOI: 10.1155/1991/43261