Mini-Thixoforming of a Steel Produced by Powder Metallurgy
نویسندگان
چکیده
منابع مشابه
Porous, Superelastic NiTi Produced by Powder-Metallurgy
Near-stoichiometric NiTi was foamed in the solid state at elevated temperatures through creep expansion of highpressure argon pores previously entrapped during powder consolidation. A sample with 17% porosity was found to be superelastic up to a compressive stress of 800 MPa.
متن کاملPorous Titanium Scaffolds Produced by Powder Metallurgy for Biomedical Applications
Department of Bioscience and Buccal Diagnosis, São Jose dos Campos School of Dentistry, State University of São Paulo – UNESP, Av. Engenheiro Francisco José Longo, 777, 12245-000 São José dos Campos SP, Brazil National Institute of Technology, Av. Venezuela, 200, Centro, Rio de Janeiro RJ, Brazil Department of Materials, Air and Space Institute, CTA, Praça Mal. do Ar Eduardo Gomes, 14, 12904-00...
متن کاملProduction and microstructural investigation of Al-nano TiB2 composite produced by powder metallurgy technique
Automotive and aerospace industries are required to light materials which have high properties. This causes to reduce production cost and fuel consumption. One of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. These materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. Powder metal...
متن کاملProduction and microstructural investigation of Al-nano TiB2 composite produced by powder metallurgy technique
Automotive and aerospace industries are required to light materials which have high properties. This causes to reduce production cost and fuel consumption. One of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. These materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. Powder metal...
متن کاملCompressibility of 304 Stainless Steel Powder Metallurgy Materials Reinforced with 304 Short Stainless Steel Fibers
Powder metallurgy (P/M) technique is usually used for manufacturing porous metal materials. However, some P/M materials are limitedly used in engineering for their performance deficiency. A novel 304 stainless steel P/M material was produced by a solid-state sintering of 304 stainless steel powders and 304 short stainless steel fibers, which were alternately laid in layers according to mass rat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Solid State Phenomena
سال: 2012
ISSN: 1662-9779
DOI: 10.4028/www.scientific.net/ssp.192-193.500