Milling Effect of Calcium Aluminate Fine Particle Prepared by Chemical Solution Processing
نویسندگان
چکیده
منابع مشابه
Variation in particle shape of active pharmaceutical ingredients prepared by fluidized-bed jet-milling.
In pharmaceutical industries, most active pharmaceutical ingredients are poorly water soluble, and therefore milling processes are important to obtain fine particles that can be easily dissolved in the body. However, the main purpose of milling is micronization of particles. From the viewpoint of fine particle preparation in the formulation process, milling has not been investigated sufficientl...
متن کاملPrediction of effect of fine particle removal on efficiency of a spiral circuit by size-by-size partition curves
Partition curves are widely used to determine the spiral separator efficiency. In this work, the partition curves were used in order to investigate the particle transportation to concentrate and tailing streams. Simulation of fine particle removal using the size-by-size partition curves showed that the recovery of gangue particles to concentrate can decrease 8.7%. It also showed that the recove...
متن کاملA Study of Nanocrystalline Cobalt Prepared by Ball Milling
The hcp-fcc transformation induced in cobalt powder by ball milling at room temperature was studied using the excess Gibbs free energy for the metals, in nanometric form, to calculate the activation barriers that the atoms must overcome for the phase transformation to occur. The crystalline component of the nanocrystaline cobalt produced in our laboratory, via ball milling, was analized using t...
متن کاملStudy of milling effect on particle size and mechanical properties of WC-Co composite
The effect of milling on the particle size and mechanical properties Tungsten Carbide - Cobalt composite were investigated. First, raw materials ratios by mechanical milling for 4 hours at 300 rpm were mixed. The powder in the optimum temperature 1350°C at a rate of temperature rise 50°C / min and shelf life of 4 minutes and the pressure MPa 30 were sintered in SPS. The results indicated nearly...
متن کاملStudy of milling effect on particle size and mechanical properties of WC-Co composite
The effect of milling on the particle size and mechanical properties Tungsten Carbide - Cobalt composite were investigated. First, raw materials ratios by mechanical milling for 4 hours at 300 rpm were mixed. The powder in the optimum temperature 1350°C at a rate of temperature rise 50°C / min and shelf life of 4 minutes and the pressure MPa 30 were sintered in SPS. The results indicated nearly...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Powder Technology, Japan
سال: 2010
ISSN: 0386-6157,1883-7239
DOI: 10.4164/sptj.47.304