Microwave discharge-pumped excimer lamp.
نویسندگان
چکیده
منابع مشابه
Femtosecond gain characteristics of the discharge-pumped ArF excimer amplifier.
The gain characteristics of a discharge-pumped ArF excimer amplifier are measured with ~700-fs-long pulses. The small-signal gain and saturation energy are found to be 0.17 cm(-1) and 3.65 +/- 0.15 mJ/cm(2), respectively. The maximum output energy density extracted from the deeply saturated amplifier is as much as 10 mJ/cm(2). The demonstrated femtosecond gain characteristics of ArF indicate th...
متن کاملOptimisation of the pulse duration of a discharge-pumped XeF( <Emphasis Type="Italic">BX </Emphasis>) excimer laser
In an x-ray preionised XeF(B~X) dischargeexcited laser driven by a magnetic-spiker sustainer circuit with a magnetic pulse compressor the influence of the various parameters on the optical pulse duration was experimentally investigated. Laser pulses at 2= 351 nm with a duration of 212 ns (FWHM) have been achieved in a NF3/Xe/Ne mixture by using very low (0.25 mbar) NF3 partial pressures in a to...
متن کاملHalogen lamp–microwave combination baking of cookies
The effects of halogen lamp–microwave combination baking on the quality of cookies in terms of texture, color and spread ratio were studied. In addition, gelatinization and pasting properties of cookies baked in different ovens were assessed by using a Rapid Visco Analyzer. The hardness values of the cookies increased with increasing baking time and/or halogen power. The microwave power also co...
متن کاملDischarge technology for excimer lasers of high average power
The self-sustained discharge of excimers is analyzed. Several excitation schemes that have been successfully applied are compared. For high repetition rate operation not only the discharge stability and its efficiency are important selection criteria but more important is the potential of fast discharge switching with minimum pulse energy. Pulse compression plays a key role in the laser perform...
متن کاملStudy on the Ionic Bombardment in a Glow Discharge Lamp
The surface of copper alloys was studied by means of a scanning electron microscope after having been sputtered by a glow discharge source under typical conditions for spectrochemical analysis. The surface topography developed during the process of sputtering gave the following two results: It would appear that the energy spread of the bombarding ions is small and the variation in the angles of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Review of Laser Engineering
سال: 1990
ISSN: 0387-0200,1349-6603
DOI: 10.2184/lsj.18.7_456