MICROWAVE-ASSISTED CENTRIFUGAL SPINNING OF GELATIN MICROFIBERS
نویسندگان
چکیده
منابع مشابه
chemical recycling of polycarbonate waste using conventional heating and microwave assisted method
پلی کربنات یکی از پلاستیکهای مهمی است که به صورت گسترده در تولید لوحهای فشرده، قطعات رایانه، مواد ساختمانی و غیره مورد استفاده قرار می گیرد. این پلیمر بصورت عمده از تراکم مونومر بیس فنولa (bpa) و کربنیل کلرید یا دی متیل کربنات ها بدست می آید. در سالهای اخیر بازیافت شیمیایی پلی کربنات بیشتر مورد توجه بوده است. بازیافت شیمیایی پلی کربنات برای بدست آوردن مواد اولیه آن با روشهای متفاوتی مانند تجزی...
Microwave-assisted synthesis of molybdenum oxide nanoparticles
This paper focused on a simple approach for synthesis of molybdenum oxide (MoO3) nanoparticles and reports a facile route for synthesis of such nanoparticles, using microwave irradiation as a homogenous and powerful source of heating, using ethylene glycol as the solvent and heating medium. For more investigations, besides microwave heating, the obtained solutions were also treated by conventio...
متن کاملPreparation and Properties of Gelatin Fibers Fabricated by Dry Spinning
Gelatin fibers have been prepared by dry spinning based on the sol-gel transition phenomena of aqueous gelatin solutions. This method is simple and environmentally friendly because only water is used for the spinning, thereby avoiding the use of any toxic organic solvents. A sol-state aqueous solution of gelatin at 50 ̋C was extruded into air through a thin nozzle at room temperature followed b...
متن کاملComposite Fibers from Recycled Plastics Using Melt Centrifugal Spinning
New methods are being developed to enable the production of value-added materials from high-volume, low-cost feedstocks arising from domestic recycling streams. In this work, recycled bottle-grade polyethylene terephthalate, polystyrene, and polypropylene were spun into fibers from the melt using a centrifugal spinning technique. Mono-component fibers and 50/50 blends of each polymer and a 33/3...
متن کاملGeneration of alginate microfibers with a roller-assisted microfluidic system.
This work describes a convenient microfluidic strategy with a simple and minimal-requirement design for the generation of uniformly-sized alginate gel fibers with diameters one order of magnitude smaller than those formed in conventional methods. Different from common microfluidic methods, our system contains a single microchannel through which alginate solutions are transported and squeezed in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Jurnal Sains Materi Indonesia
سال: 2020
ISSN: 2614-087X,1411-1098
DOI: 10.17146/jsmi.2020.21.2.5834