Microwave and conventional sintering of premixed and prealloyed Cu-12Sn bronze
نویسندگان
چکیده
منابع مشابه
chemical recycling of polycarbonate waste using conventional heating and microwave assisted method
پلی کربنات یکی از پلاستیکهای مهمی است که به صورت گسترده در تولید لوحهای فشرده، قطعات رایانه، مواد ساختمانی و غیره مورد استفاده قرار می گیرد. این پلیمر بصورت عمده از تراکم مونومر بیس فنولa (bpa) و کربنیل کلرید یا دی متیل کربنات ها بدست می آید. در سالهای اخیر بازیافت شیمیایی پلی کربنات بیشتر مورد توجه بوده است. بازیافت شیمیایی پلی کربنات برای بدست آوردن مواد اولیه آن با روشهای متفاوتی مانند تجزی...
Udk 622
The aim of the present investigation is to study the sintering behavior of the Cu12Sn bronze system in both, a microwave furnace as well as a conventional furnace. The powders prepared by premixed and prealloyed routes were sintered in the range of solid state, transient and supersolidus liquid phase sintering conditions. The comparative analysis is based on the sintered density, densification ...
متن کاملEFFECT OF SUPERSOLIDUS LIQUID PHASE SINTERING ON THE MICROSTRUCTURE AND DENSIFICATION OF THE Al-Cu-Mg PREALLOYED POWDER
Abstract: The supersolidus liquid phase sintering characteristics of commercial 2024 pre-alloyed powder was studied at different sintering conditions. Pre-alloyed 2024 aluminum alloy powder was produced via air atomizing process with particle size of less than 100 µm. The solidus and liquidus temperatures of the produced alloy were determined using differential thermal analysis (DTA). The sinte...
متن کاملDENSIFICATION AND MICROSTRUCTURE CHARACTERISTICS OF A PREALLOYED ALPHA BRASS POWDER PROCESSED BY LIQUID PHASE SINTERING
The rapidly solidified prealloyed alpha brass powder with a size range of 40 to 100 μm produced by water atomization process was consolidated using liquid phase sintering process. The relationships between sintering temperature, physic-mechanical properties and microstructural characteristics were investigated. Maximum densification was obtained at 930 °C, under 600 MPa compacting pressure,...
متن کاملMicrowave Sintering of Mullite
Microwave sintering possesses unique attributes and has the potential to be development as a new technique for controlling microstructure and to improve the properties of advanced ceramics. Because microwave radiation penetrates most ceramics, uniform volumetric heating is possible. Thermal gradients, which are produced during conventional sintering because of conductive and radioactive heat tr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science of Sintering
سال: 2003
ISSN: 0350-820X,1820-7413
DOI: 10.2298/sos0302049s