Microtensile creep testing of freestanding MCrAlY bond coats
نویسندگان
چکیده
منابع مشابه
Development of APS MCrAlY Dense Bond Coats
The objective of this study was to mimic the microstructure of MCrAlY coatings sprayed using HVOF (High Velocity Oxy-Fuel) processes by using an Air Plasma Spray (APS) process in order to improve oxidation and spallation life of MCrAlY APS coatings. Figure 1 shows the typical microstructures obtained when spraying bond coats using the (a) HVOF process, and (b) the APS process. The microstructur...
متن کاملMicrotensile bond strength of clearfil SE bond to caries-affected dentin and normal dentin
Microtensile bond strength of clearfil SE bond to caries-affected dentin and normal dentin Dr. A. Ghasemi* - Dr. M. Bargrizan** - Dr. M. Mahmoodi*** *- Assistant Professor of Operative Dentistry Dept. - Faculty of Dentistry – Shaheed Beheshti University of Medical Sciences. **- Assistant Professor of Pedodontics Dept. - Faculty of Dentistry – Shaheed Beheshti University of Medical Sciences. ***...
متن کاملMicrotensile Bond Strength of Self-Adhesive Luting Cements to Ceramics
The purpose of this paper was to compare the bond strengths of the self-adhesive luting cements between ceramics and resin cores and examine their relation to the cement thickness. Three self-adhesive luting cements (Smartcem, Maxcem, and G-CEM) and a resin cement (Panavia F 2.0) for control were used in the paper. The thickness of the cements was controlled in approximately 25, 50, 100, or 200...
متن کاملMicrotensile bond strength of repaired indirect resin composite
PURPOSE The objective of this study was to investigate the effect of surface treatments on microtensile bond strengths (MTBSs) of two types of indirect resin composites bonded to a conventional direct resin composite. MATERIALS AND METHODS Indirect resin composite blocks of Ceramage and SR Nexco were prepared in a plastic mold having a dimension of 10 × 10 × 4 mm. These composite blocks were ...
متن کاملMicrotensile bond strength of bulk-fill restorative composites to dentin
BACKGROUND To facilitate the easier placement of direct resin composite in deeper cavities, bulk fill composites have been introduced. The Mechanical stability of fillings in stress bearing areas restored with bulk-fill resin composites is still open to question, since long term clinical studies are not available so far. Thus, the objective of the study was to evaluate and compare the microtens...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Research
سال: 2019
ISSN: 0884-2914,2044-5326
DOI: 10.1557/jmr.2019.169