Microstructures and high-temperature self-lubricating wear-resistance mechanisms of graphene-modified WC-12Co coatings

Self-lubricating, low-friction, wear-resistant Al-based quasicrystalline coatings

After gas atomization, a quasicrystalline powder based on aluminium was used to prepare a thick coating by high-velocity oxygen-fuel flame torch spraying. This layer was deposited on top of a bond-coat layer on a steel plate. A post-spraying annealing treatment turned the two layers to their stable state, a γ-brass crystal and an icosahedral quasicrystal, respectively. The projection parameters...

High Temperature Self-Lubricating Materials

Experimental and Numerical Study of Residual Stress in the WC-12Co HVOF Sprayed Coatings

Thermally sprayed coatings are intrinsically associated with residual stresses in the deposits. These stresses are varied in nature and magnitude, and have a pronounced effect on the mechanical behavior of the system. In the current study, WC-12Co coatings were deposited using HVOF thermal spraying. The sin2ψ method was used to evaluate the through thickness residual stress by means ...

The Study of High Temperature Oxidation behavior of Different Microstructures of HVOF Thermally Sprayed Coatings

Improvement of thermally sprayed coating properties by microstructure modification has been considered as a significant solution. Therefore, in this research the effect of dissolved oxygen content and post heat treatment on the formation and distribution of secondary phase particles, particularly in nano-scale in the coatings during spraying and after that were studied. Ni-5 wt% Al powders were...

Effect of WC Concentration on Abrasive Wear Properties of the Thermally Sprayed WC -Ni Coatings

In this work the effects of WC concentration on abrasive wear behavior by thermally sprayed WC coating was evaluated using three body abrasive wear tester. A different combination of WC and NI coatings were deposited on steel substrates by flame spraying using powder with different WC concentrations (0 %, 12.5 %, 25 %, and 50 %). Flame torch was used for heating and coating of process. Microstr...