Microstructure & Tribological Performance of Alumina-3wt% Titania Coatings Produced by APS
نویسندگان
چکیده
منابع مشابه
Microstructure and Tribological Performance of TiB2-NiCr Composite Coating Deposited by APS
Nickel chromium (NiCr) powders with different titanium diboride (TiB2) additions (20, 40 and 60 wt %) were prepared with a mechanical alloying method and then sprayed using an air plasma spraying technology. The microstructure and phase composite of the powders and the cross-sections of deposited coatings were analyzed with a scanning electronic microscope and X-ray diffraction. The tribologica...
متن کاملFuzzy Logic Analysis of Alumina–Titania Deposition Yield During APS Process
The behavior modeling of Atmospheric Plasma Spray (APS) process requires a global approach which considers interrelated non-linear relationships between coating characteristics / properties in-service and process parameters (power, feedstock injection, kinematics, etc.). Such an approach would permit to reduce the development costs. To reach this objective, the knowledge of the interactions bet...
متن کاملTribological Performance of MoS2 Coatings in Various Environments
Molybdenum disulfide (MoS2) is a well-known solid lubricant for tribosystems running in vacuum or dry gases. Problems arise due to its sensitivity to humidity, which is a drawback for its application under ambient conditions. However, by using a physical vapor deposition (PVD) process, deposition parameters can be optimized not only to gain a coatings structure with favorable frictional propert...
متن کاملEffect of TiO2 addition on the microstructure and nanomechanical properties of Al2O3 Suspension Plasma Sprayed coatings
Alumina-titania coatings are widely used in industry for wear, abrasion or corrosion protection components. Such layers are commonly deposited by atmospheric plasma spraying (APS) using powder as feedstock. In this study, both Al2O3 and Al2O3-13 wt% TiO2 coatings were deposited on austenitic stainless steel coupons by suspension plasma spraying (SPS). Two commercial suspensions of nanosized Al2...
متن کاملMicrostructure and Corrosion Performance of Silica Coatings on Aluminum Surface Prepared by Plasma Electrolysis Technique
Silica phases were precipitated on aluminum surface by potentiostatic plasma electrolysis technique. Aqueous sodium silicate solutions with different concentrations were used for this purpose. SEM, EDS, XRD, surface profiles and polarization curves were used to study coatings properties. The results showed that the growth of the silica containing phases on aluminum surface was promoted by incre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Computational and Experimental Science and Engineering
سال: 2020
ISSN: 2149-9144
DOI: 10.22399/ijcesen.665097