Microstructure, Strength and Toughness of Maraging Steels
نویسندگان
چکیده
منابع مشابه
A New Maraging Stainless Steel with Excellent Strength–Toughness–Corrosion Synergy
A new maraging stainless steel with superior strength-toughness-corrosion synergy has been developed based on an innovative concept of alloy design. The high strength-toughness combination is achieved by forming dispersive nano-sized intermetallic compounds in the soft lath martensitic matrix with a slight amount of residual austenite. The good corrosion resistance is guaranteed by exactly cont...
متن کاملUltrahigh Charpy impact toughness (~450J) achieved in high strength ferrite/martensite laminated steels
Strength and toughness are a couple of paradox as similar as strength-ductility trade-off in homogenous materials, body-centered-cubic steels in particular. Here we report a simple way to get ultrahigh toughness without sacrificing strength. By simple alloying design and hot rolling the 5Mn3Al steels in ferrite/austenite dual phase temperature region, we obtain a series of ferrite/martensite la...
متن کاملCarbide Structure and Fracture Toughness of High Speed Tool Steels
In the present study, M2 high speed steels were fabricated by using electro-slag rapid remelting process. Carbide structure was analysed and the fracture toughness and hardness were also measured after austenitization treatment at 1190 and 1210C followed by tempering treatment at 535C for billets with various diameters from 16 to 60 mm. Electro-slag rapid remelting (ESRR) process is an advanced...
متن کاملMicrostructure and cleavage in lath martensitic steels
In this paper we discuss the microstructure of lath martensitic steels and the mechanisms by which it controls cleavage fracture. The specific experimental example is a 9Ni (9 wt% Ni) steel annealed to have a large prior austenite grain size, then examined and tested in the as-quenched condition to produce a relatively coarse lath martensite. The microstructure is shown to approximate the recen...
متن کاملHigh-Strength Bainitic Steels
With careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thin films of stable retained austenite have exhibited impressive combinations of strength and toughness in highsilicon bainitic steels. The silicon suppresses the precipitation of brittle cementite leading to an improvement in toughness. The essential principles governing the optimisatio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Japan Institute of Metals
سال: 1975
ISSN: 0021-4426,1884-5835
DOI: 10.2320/materia1962.14.767