Microstructure of Electron Beam Welded Cu / STS 304 Dissimilar Materials
نویسندگان
چکیده
منابع مشابه
Micro-Study of Dissimilar Welded Materials
The dissimilar joint between aluminum/titanium alloys (Al 6082 and Ti G2) were successfully achieved by CO2 laser welding with a single pass and without filler material using the overlap joint design. Laser welding parameters ranges combinations were experimentally determined using Taguchi approach with the objective of producing welded joint with acceptable welding profile and high quality of ...
متن کاملWeld Quality Analysis of Tig, Laser and Electron Beam Welded Ss 304 and 316 Materials with Ndt Techniques
The development and fabrication of fusion reactor components utilize different grades of stainless steel materials and different welding techniques. Major candidates are TIG welding, Laser welding and Electron beam welding and Narrow Gap TIG welding. The weld joints quality evaluation and their mechanical properties are to be analyzed for performance of these developed components. The welded jo...
متن کاملControl of Welding Residual Stress for Dissimilar Laser Welded Materials
The most common problem of welding dissimilar metals (DMWs) with respect to residual stresses is the differences in the coefficient of thermal expansion and heat conductivity of the two welded metals. In the present work, a CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and low carbon steel plates. The Taguchi approa...
متن کاملOptimization of Process Parameters of Electron Beam Welded Fe49Co2V Alloys
Electron beam welding has shown a remarkable job in the space industry for welding of components. It is performed under a vacuum environment that eliminates foreign matter such as hydrogen, oxygen, and other gases. Joining of similar and dissimilar materials is the main advantage of electron beam welding with high depth to width ratio as well as sharp focus at the point where parts are to be we...
متن کاملModeling of input-output Relationships for electron beam butt welding of dissimilar materials using Neural Networks
Electron beam butt welding of stainless steel (SS 304) and electrolytically tough pitched (ETP) copper plates was carried out according to central composite design of experiments. Three input parameters, namely accelerating voltage, beam current and weld speed were considered in the butt welding experiments of dissimilar metals. The weld-bead parameters, such as bead width and depth of penetrat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Welding and Joining Society
سال: 2010
ISSN: 1225-6153
DOI: 10.5781/kwjs.2010.28.2.047