Microstructure evolution during tempering of martensitic Fe–C–Cr alloys at 700 °C
نویسندگان
چکیده
منابع مشابه
Microscale simulation of martensitic microstructure evolution.
A new model for the evolution of multivariant martensitic microstructure in single crystals and polycrystals is developed. In contrast with Landau-Ginzburg models, which are limited in practice to nanoscale specimens, this new scale-free model is valid for length scales greater than 100 nm and without an upper bound. It is based on a thermodynamic potential in the volume fractions of the marten...
متن کاملThe Effect of Tempering Treatment on the Microstructure and Mechanical Properties of DIN 1.4021 Martensitic Stainless Steel
To investigate the effect of tempering treatment on mechanical properties and the microstructure of DIN 1.4021 Martensitic Stainless Steel, austenite treatment was conducted for the samples at 1000 ºC temperature for 60 min and then the samples were oil quenched. Later, tempering treatments were performed for the samples at 500 ºC and 700 ºC temperatures for 2 and 5 h, respectively; then quench...
متن کاملPhase Transitions During Continuous Heating of Martensitic CuAlMn Alloys
Phase transitions in CuAlMn alloys containing up to 12 at% Mn and 27 at% A1 continuously heated up to 5500C were studied using differential scanning calorimetry and transmission electron microscopy. Alloys containing less than 4.8 at% Mn exhibit an exothermal heat effect in the range 280 380°C due to y2 precipitation. The additional endothermal peak above 5000C is caused by DO3 disordering. All...
متن کاملModelling and characterisation of Mo2C precipitation and cementite dissolution during tempering of Fe-C-Mo martensitic steel
The precipitation and Ostwald ripening behaviour of needle shaped Mo2C particles during the tempering of a ternary Fe –C –Mo martensitic steel have been characterised and modelled, taking account of local equilibrium, the capillarity effect, and the simultaneous enrichment and dissolution of cementite. Particles of Mo2C are represented as paraboloids of revolution, with the tip radius chosen to...
متن کاملWet oxidation of GeSi at 700 “C
About 500-nm-thick films of Ge,-,,6Sic64 and Ge o.28Si0.72 grown epitaxially on ( 100)Si have been oxidized at 700 “C in wet ambient. A uniform Ge,Sit -,O, oxide layer forms with a smooth interface between it and the unoxidized Ge$i, _ X layer below. The composition and structure of that layer remains unchanged as monitored by backscattering spectrometry or cross-sectional transmission electron...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Science
سال: 2018
ISSN: 0022-2461,1573-4803
DOI: 10.1007/s10853-018-2036-7