Microstructure control using severe plastic deformation
نویسندگان
چکیده
منابع مشابه
MICROSTRUCTURE AND MECHANICAL PROPERTIES OF THE ULTRAFINE-GRAINED COPPER TUBE PRODUCED BY SEVERE PLASTIC DEFORMATION
In this paper, cyclic flaring and sinking (CFS) as a new severe plastic deformation (SPD) method was employed to produce the ultrafine grain (UFG) copper tubes. The extra friction has eliminated in the CFS method that provided the possibility for production of longer UFG tubes compared to the other SPD methods. This process was done periodically to apply more strain and consequently finer grain...
متن کاملTHE EFFECT OF SEVERE PLASTIC DEFORMATION ON THE MICROSTRUCTURE AND MECHANICAL PROPERTIES OF AS-CAST AZ31
The evolution of microstructure and mechanical properties of a magnesium cast alloy (AZ31) processed by equal channel angular pressing (ECAP) at two different temperatures were investigated. The as-cast alloy with an average grain size of 360 was significantly refined to about 5 after four ECAP passes at 543 K. Grain refinement was achieved through dynamic recrystallization (DRX) du...
متن کاملSevere Plastic Deformation of Metals
This paper provides an introduction in the field of severe plastic deformation (SPD). First of all the main methods to produce SPD materials are discussed. In the following section, the mechanisms leading to the formation of fine grains are reviewed and the influence of changes in strain path is highlighted. During post-SPD thermal annealing, some typical microstructural changes take place. The...
متن کاملNumerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملInvestigation of microstructure and mechanical properties of low carbon steel sheets after severe plastic deformation in corrugation dies
Recently, bulk nano-structured materials produced by severe plastic deformation (SPD) have attracted scientists attention. Materials produced by SPD are of great importance because of (1) non-porous structure, (2) great mechanical properties such as high strength and toughness and (3) proper dimension for mechanical and physical testing. Several methods have been introduced for imposing the s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science and Technology of Advanced Materials
سال: 2006
ISSN: 1468-6996,1878-5514
DOI: 10.1016/j.stam.2006.05.011