Microstructure characterization of ODS-RAFM steels
نویسندگان
چکیده
منابع مشابه
High heat flux testing of 12–14Cr ODS ferritic steels
0022-3115/$ see front matter 2009 Published by doi:10.1016/j.jnucmat.2009.09.022 * Corresponding author. E-mail address: [email protected] (Z. Oksiut The thermal performance of Fe–(12–14)Cr–2W–0.3Ti–0.3Y2O3 ODS reduced activation ferritic steels, which are considered as candidate first wall materials for the future fusion power reactors and were manufactured by mechanical alloying in hydr...
متن کاملModelling the Microstructure of Martensitic Steels
A method based on the kinetics of crystal growth has been developed and applied to the computation of three-dimensional microstrucuture in austenite-matensite steels. The detailed crystallography of the transformation is used to model a realistic martensitic microstrucuture during the transformation without an external system of stresses. The interaction energy based on the plastic work model i...
متن کاملMicrostructure and cleavage in lath martensitic steels
In this paper we discuss the microstructure of lath martensitic steels and the mechanisms by which it controls cleavage fracture. The specific experimental example is a 9Ni (9 wt% Ni) steel annealed to have a large prior austenite grain size, then examined and tested in the as-quenched condition to produce a relatively coarse lath martensite. The microstructure is shown to approximate the recen...
متن کاملAssessment of Microstructure Degradation of Creep Exposed Boiler Steels
Under the influence of temperature and stresses, the heat resistant materials react by creeping. Boiler components subjected to creep have a limited lifetime. Creep and material structure evolution are tightly related and according to this rule a number of studies have been performed in order to relate micro structural investigation and service exposure or residual life. The determination of th...
متن کاملMicrostructure Evolution of HSLA Pipeline Steels after Hot Uniaxial Compression
The mechanical properties of the high-strength low-alloy pipeline steels were mainly controlled by the subsequent phase transformations after rolling. The influence of hot uniaxial compression on the phase transformation of acicular ferrite was explored by viewing of the deformation degree, the deformation temperature, and the strain rate. The results show that the increase of deformation amoun...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MRS Proceedings
سال: 2008
ISSN: 0272-9172,1946-4274
DOI: 10.1557/proc-1125-r05-03