Microstructure characterization of melt spun Mg65Cu225Y10
نویسندگان
چکیده
منابع مشابه
Mechanical response of melt-spun amorphous filaments
High-speed melt spinning of a cyclo-olefin polymer (COP) and a copolyamide (CoPA) have been performed. Differential scanning calorimetry curves of the resulting monofilaments show that they remain in an amorphous state even after hot drawing. Wide angle x-ray diffraction patterns of undrawn and drawn COP filaments show that although the material remains in an amorphous state, a degree of orient...
متن کاملMicrostructure and magnetic domain structure of boron - enriched Nd 2 ( FeCo ) 14 B melt - spun ribbons
Heat treated melt-spun ribbons of (Nd La) Fe Co Nb B have been studied systematically by supercon-ducting quantum interference device (SQUID) magnetometry, conventional transmission electron microscopy (CTEM) and Lorentz transmission electron microscopy (LTEM). The sample's microstructure grew from an amorphous state through a partially crystallized state at 6503C, and "nally to a fully crystal...
متن کاملCOERCIVITY MECHANISM OF MELT-SPUN Sm(Fel1Ti)
Hysteresis loops of randomly oriented grains with uniaxial anisotropy were computed on the basis of an array of 27 Wigner Seitz cells representing crystallites which interact by exchange coupling at the grain boundaries. The computed coercivity increases linearly with increasing interatomic exchange. Using the experimental anisotropy and exchange parameters for Sm(FellTi), we found 1.lo&=1.2 T ...
متن کاملMagnetic properties and synthesis conditions of Nd2Fe23B3 melt-spun alloy
The formation of amorphous and crystalline state of the Nd2Fe23B3 alloy from melt-spun ribbon is presented. The synthesis conditions are investigated combining DSC, X-ray diffraction and thermomagnetic analysis. The thermomagnetic analysis is found to be very useful to optimize the synthesis process. Comparison of these results enables to discuss the thermal stability of both the amorphous and ...
متن کاملHard magnetic properties of melt-spun Mn-Al-C alloys
Structural and magnetic characterization of Mnx−yAl100−x−yC2y (x = {50, 55}; y = {0, 1}) melt-spun ribbons is reported. To obtain the metastable ferromagnetic τ-phase, rapidly solidified alloys were annealed either in a vacuum furnace at 823 K or directly in the vibrating sample magnetometer under applied magnetic field. Optimal magnetic properties were demonstrated by Mn54Al44C2 samples proved...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallic Materials
سال: 2017
ISSN: 0023-432X
DOI: 10.4149/km_2017_1_1