Microstructure and Wear Behaviour of Matrix Al7075 Reinforced With Micro Wc-Co Particulate Composite Processed by Stir Casting Method
نویسندگان
چکیده
منابع مشابه
Effect of Hexagonal Boron Nitrate on Microstructure and Mechanical Behavior of Al7075 Metal Matrix Composite Producing by Stir Casting Technique
Al7075 alloy reinforced with h-Boron Nitrate (BN) composites were processed by stir casting technique. The produced composite was subjected to microstructural studies using OLYMPUS -BX51M, tensile, hardness, density and wear tests. Tensile strength and hardness were found to increase by 12.8% and 20% respectively due to increased dislocation density with the addition of reinforcement. Microstru...
متن کاملMicrostructure and Dry-Sliding Wear Behavior of B4C Ceramic Particulate Reinforced Al 5083 Matrix Composite
B4C ceramic particulate–reinforced Al 5083 matrix composite with various B4C content was fabricated successfully via hot-press sintering under Argon atmosphere. B4C particles presented relative high wettability, bonding strength and symmetrical distribution in the Al 5083 matrix. The hardness value, friction coefficient and wear resistance of the composite were higher than those of the Al 5083 ...
متن کاملStudy on Iraqi bauxite ceramic reinforced Aluminum metal matrix composite synthesized by stir casting
For the past decades researchers are showing immense interest to investigate the natural advantage of preparation of composites from minerals such as bauxite particles, and proved their effectiveness as cost effective reinforcing agents in fabrication of high performance composites. This study, is a new attempt in using the Iraqi natural bauxite powder with different proportions (2wt%, 4wt%, an...
متن کاملan investigation into the wear behaviour of aluminum (aa2124) matrix composite reinforced with intermetallic mosi2 particles
in the present work, the aa2124/25vol.%mosi2 composite was produced by powder metallurgy technique. the aluminum alloy 2124 powder was produced by gas atomization method and the mosi2 intermetallic particles were produced through combustion synthesis. the aa2124 matrix powder was mechanically blended with 25vol.%mosi2 using a ball milling mixer. the blended powder mixture was encapsulated and t...
متن کاملThe Effect of Rotation Speed on the Microstructure and Hardness of Synthesized Al-WC Nano-Composite by Centrifugal Casting
The aim of this work was WC distribution in base Al-Si-Mg (A356) alloy as reinforcing agent. WC Solid particles in the sub-23-nm size range added to melted alloy by centrifuge casting. The cylinder tube without gap was obtained. FESEM and OPM results show that the distribution depends upon the rotational speeds of the mould and centrifugal casting conditions. According to the MAP results, durin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-899X
DOI: 10.1088/1757-899x/1013/1/012020