Microstructure and Toughness of Friction Stir Weld of Thick Structural Steel
نویسندگان
چکیده
منابع مشابه
Evaluation of microstructure and mechanical properties of friction stir welded copper / 316L stainless steel dissimilar metals
In the present research, friction stir welding (FSW) process was used for butt joining of pure copper plate to 316L stainless steel plate. Mechanical properties and microstructural characteristics of the joint were evaluated by microhardness and tensile tests as well as optical and scanning electron microscope (SEM). It was found that microstructure of the weld nugget (WN) has fine grains where...
متن کاملOptimization of friction stir welding parameters for toughness in super duplex stainless steel
In this paper, using the Taguchi method, the parameters affecting the toughness of super duplex stainless steels in friction stir welding were optimized. In order to achieve optimal conditions, maximum toughness, the quality characteristic was used as the higher the better. Analysis of Taguchi results showed that in order to achieve optimal conditions in super duplex stainless steel weldments m...
متن کاملMicrostructure and Residual Stress Formation in an Aa6040 to Az31b Friction Stir Weld
The microstructure and residual stresses of an AA6040 Al to AZ31B Mg friction stir weld are studied using scanning electron microscopy and X-ray diffraction. The complex material flow promoted by the friction stir welding process results in a fine grained structure in the stir zone of both materials due to dynamic/recovery recrystallization. The interface between the materials is characterized ...
متن کاملOptimization of friction stir welding parameters for toughness in super duplex stainless steel
In this paper, using the Taguchi method, the parameters affecting the toughness of super duplex stainless steels in friction stir welding were optimized. In order to achieve optimal conditions, maximum toughness, the quality characteristic was used as the higher the better. Analysis of Taguchi results showed that in order to achieve optimal conditions in super duplex stainless steel weldments m...
متن کاملSize distribution of oxides and toughness of steel weld metals
The trend in strong weld metals is towards microstructures dominated by low carbon martensite. The role of oxide particles introduced into the metal during welding then becomes uncertain. The particles do not seem to affect the nucleation or growth of martensite. This is probably because this phase forms at relatively large driving forces and therefore does not rely on heterogeneous nucleation ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2012
ISSN: 0915-1559,1347-5460
DOI: 10.2355/isijinternational.52.1335