Microstructure and tensile properties of microalloyed Zn-xMg alloys

نویسندگان

چکیده

Abstract Zn-xMg alloys with different Mg contents were prepared by adding the element to pure Zn. The effects of on microstructure and tensile properties studied scanning electron microscopy, XRD ray diffractometer, test. results show that Zn is composed coarse grains, there are twins in morphology. diffraction peak mainly β-Zn. After element, α-Mg, 2 11 , peaks appear pattern. With increase content alloy, number increases. It found strength plasticity alloy content. fracture morphology rock or without has obvious brittle characteristics.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The microstructure , tensile properties , and creep behavior of Mg – Zn alloys containing 0 – 4 . 4 wt . % Zn

This paper describes the microstructure, tensile, and tensile–creep behavior of a series of Mg–Zn alloys ranging from 0 to 4.4 wt.% Zn. The microstructures consisted of equiaxed hexagonal-close-packed grains with fine precipitates preferentially located at grain boundaries. Some of the microstructures contained fine laths within the equiaxed grains. The finest grain sizes were observed for a Zn...

متن کامل

Microstructure of Al-Zn and Zn-Al Alloys*

The change of microstructure of the title alloys with concentration, temperature and applied thermal treatment was studied in situ by XRD. The alloys, having the Zn atomic fraction, x(Zn), from 0.03 to 0.62, were subjected to: (i) rapid quenching from a temperature, Tt, higher than the solid-solution temperature, Tss, in water at RT (samples WQ); (ii) slow cooling from Tt to RT (samples SC). Th...

متن کامل

Effect of Finish Rolling Temperature on the Microstructure and Tensile Properties of Nb–Ti Microalloyed X90 Pipeline Steel

The relationship between microstructure and tensile properties of an Nb–Ti microalloyed X90 pipeline steel was studied as a function of finish rolling temperature using a Gleeble 3500 simulator, an optical and scanning electron microscope, electron back scattered diffraction (EBSD), a transmission electron microscope (TEM) and X-ray diffraction. The results indicate that the microstructure is p...

متن کامل

EFFECTS OF MO ADDITION ON THE MICROSTRUCTURE AND MECHANICAL PROPERTIES OF CAST MICROALLOYED STEEL

In industry, the cost of production is an important factor and it is preferred to use conventional and low cost procedures for producing the parts. Heat treatment cycles and alloying additions are the key factors affecting the microstructure and mechanical properties of the cast steels. In this study an attempt was made to evaluate the influence of minor Mo addition on the microstructure and me...

متن کامل

Microstructure, Tensile and Creep Properties of Ta20Nb20Hf20Zr20Ti20 High Entropy Alloy

This paper examines the microstructure and mechanical properties of Ta20Nb20Hf20Zr20Ti20. Two casting processes, namely, gravity casting and suction-assisted casting, were applied, both followed by Hot Isostatic Pressing (HIP). The aim of the current study was to investigate the creep and tensile properties of the material, since the literature review revealed no data whatsoever regarding these...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of physics

سال: 2023

ISSN: ['0022-3700', '1747-3721', '0368-3508', '1747-3713']

DOI: https://doi.org/10.1088/1742-6596/2557/1/012097