Microstructure and Solidification Process of Fe-Cu Immiscible Alloy by Using Containerless Process
نویسندگان
چکیده
منابع مشابه
Production of W-Cu-Ni Alloy and Cu Bimetal by SPS Process and Analysis of Process Parameters
This study aims at investigating changes in microstructure and strength of W alloy and Cu bimetals with varying spark plasma sintering (SPS) temperature and percentage of copper in W-Cu-Ni alloy. After SPS of W (12 wt%)-Cu (14 wt%)-Ni (3 wt%) alloy powder into consolidated discs at 1350 ° C, they were spark plasma sintered to copper discs at various temperatures. Assessment of the interface mic...
متن کاملUnraveling the Effects of Process Control Agents on Mechanical Alloying of Nanostructured Cu-Fe Alloy
Nanostructured Cu-20Fe alloy was synthesized by mechanical alloying process and the effects of process control agents (PCA) on the phase formation, crystallite refinement and morphology of powder particles were studied. The dissolution of Fe into Cu matrix and the morphology of powder particles were analyzed by X-ray diffraction (XRD) technique and scanning electron microscopy (SEM), respective...
متن کاملIn Situ and Real-Time Observation of the Solidification Process of Al20mass%Cu Alloy by Synchrotron X-ray Radiography
High brilliance synchrotron X-ray radiography has been used to in situ study the solidification process of Al20mass%Cu alloy with nominal spatial and temporal resolutions of 7.4 μm and 300ms, respectively. The block of favorably oriented dendrites by the unfavorably oriented ones was first observed in metal solidification, which related to solute interaction of neighbor dendrites. Solute inter...
متن کاملInfluence of Preparation Process on Microstructure, Critical Current Density and Tc of MgB2/Fe/Cu Wires
The powder-in-tube MgB2 wires were prepared by high energy milling of Mg and B powder. The powder was not mechanically alloyed for 2h short milling time. However, the MgB2 grains in wires are very small (20 100nm) and resembled to the dimple after post-heat treatment. The clear evidence for transcrystlline fracture is observed. It indicated that the grain connection was greatly improved and the...
متن کاملDechlorination of carbon tetrachloride by the catalyzed Fe-Cu process.
The electrochemical reduction characteristics of carbon tetrachloride (CT) were investigated using cyclic voltammetry in this study. In addition, the difference in reduction mechanisms of CT between Master Builders' iron and the catalyzed Fe-Cu process was discussed. The results showed that CT was reduced directly on the surface of copper rather than by atomic hydrogen produced at the cathode i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 2017
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet.jbw201608